A06B-6142-H002#H580

[][]Module Schneider controller module BB robot Bailey [][] [][] Module servo drive Westinghouse B module card [][]
[][]Siemens R module R Huo Nivel Driver[][]
● Contact person: Wu Jinhui
● Contact number: - or ++ WeChat
● Contact:
● Contact fax:
● Working temperature: abundant supply, strong strength
● Storage conditions: mostly in stock, meeting demand
● Working temperature: quality assurance, buy with confidence
● Mean time between failures:
Flash alarm requirements
When the user needs it, the equipment can be equipped with a complete flash signal device and corresponding test button.
Fault alarm requirements
When the AC power supply loses voltage (including phase failure), the charging device fails, the insulation monitoring device fails, or the battery pack and other fuses blow, the equipment should be able to reliably send out an alarm signal.
Requirements for microcomputer monitoring device
Control program
The monitoring device should have control programs for charging, long-term operation, and AC interruption.
The microcomputer monitoring device can automatically perform constant current and voltage limiting charging - constant voltage charging - float charging - and enter the normal charging operation state.
According to the setting time, the microcomputer monitoring device will automatically balance the charge of the battery pack.
Display and alarm function
The monitoring device should be able to display the AC input voltage, DC control bus voltage, DC power bus voltage, charging voltage, battery pack voltage, charging device output current, battery charging and discharging current, etc. parameter.
The monitoring device should be able to set and modify its parameters. If the following conditions are found: abnormal AC voltage, charging device failure, abnormal bus voltage, abnormal battery voltage, bus grounding, etc., corresponding signals and audible and visual alarms should be issued. Its protection and alarm functions should comply with the provisions of.
The monitoring device can self-diagnose internal circuit faults and abnormal operating conditions, and can issue audible and visual alarms.
Three remote functions
The monitoring device should be equipped with a communication interface to realize remote signaling, telemetry and remote control of the equipment. Its main functional requirements are shown in the table.
-Module
High voltage bar
Siemens high voltage bar
3 accessories
-Motor
Drive
-Power supply
- Power supply
/> Omron Encoder
- Module
Card
Fanuc Operation Panel Membrane Key
- Acquisition Card
B Sensor
Fanuc B Driver
BB motor
Honeywell card
/ AC servo drive
R-drive
Power meter
Relay module
Siemens drive< br/> Fanuc B Board
Mitsubishi Inverter
R/Accessories
R3/Accessories