A06B-6250-H011

[][]Module Schneider controller module BB robot Bailey [][] [][] Module servo drive Westinghouse B module card [][]
[][]Siemens R module R Huo Nivel Driver[][]
● Contact person: Wu Jinhui
● Contact number: - or ++ WeChat
● Contact:
● Contact fax:
● Working temperature: abundant supply, strong strength
● Storage conditions: mostly in stock, meeting demand
● Working temperature: quality assurance, buy with confidence
● Mean time between failures:
AC interruption program test
Test according to the method.
After the AC power is restored, the charging device enters the charging process.
Monitoring device display and detection function test
According to the requirements, the equipment operating parameters are displayed. The actual value, the set value and the measured value should comply with the product technical conditions.
For artificially simulated faults, the device should send a signal and alarm, and the action value and set value should comply with the product technical conditions.
Three remote function test
Remote signaling test
Manually simulate various faults, and should be able to receive various alarm signals and equipment operating status indication signals through the host computer connected to the communication interface of the monitoring device.
Remote test test
To change the operating status of the equipment, the host computer connected to the communication interface of the monitoring device should be able to receive the data in the current operating status sent by the device through the communication interface of the monitoring device.
Remote control test
The equipment should be able to switch on, off, charge, and float charge states through the host computer connected to the communication interface of the monitoring device.
Electromagnetic compatibility (immunity) test
Oscillatory wave immunity test
The equipment is operated under normal conditions, and the attenuated oscillation waves with frequencies of and and the first half-wave voltage are input respectively. The amplitudes are for the common mode test over time and the differential mode test over time. During the common mode and differential mode tests, the equipment can operate normally or the equipment can resume normal operation after the test.
Test location:
Common mode test between independent circuits and ground
Differential mode test between terminals of the same circuit.
Electrostatic discharge immunity test
When the equipment is running under normal conditions, the test voltage is applied using the contact discharge method on the panel of the equipment, buttons, knobs, switch handles, etc. that are easy to access during normal operation. For a single discharge, each test point should be repeated times with the positive and negative poles of the test voltage respectively, and the time interval should be. The equipment can operate normally during the test, or the equipment can resume normal operation after the test.
- Accessories
God Vision Sensor-Sensor

Fanuc B/Network Card
- Required - Controller and cable
Agilent- Accessories< br/> Power module
Cylinder
Siemens - Inductor
Servo drive
Omron photoelectric switch
Omron - Photoelectric switch
Panasonic Servo motor
Mitsubishi Mitsubishi Series Modules
Siemens Thermal Relay
- -
3 Modules
3 Modules
-Switch
. Relay
United States. -Controller
Siemens frequency converter
Reciprocating saw
Angle grinder
Battery
Battery
Siemens battery
- Engraving machine
Marine Temperature sensor
-Connector
Make up the price difference Make up the price difference Make up the price difference
Emerson-Accessories
Yaskawa-Accessories
. Card
Fanuc B driver
Accessories
- Modules
- Modules