120 square meters multi-stranded tinned copper wire factory direct sales

Square multi-strand tinned copper wire factory direct sales
Whether it is observed in the chemical composition, surface state, or organizational structure, when everyone carefully observes the copper stranded wire or copper braided wire, it will be obvious that the surface Corrosion, discoloration, and blackening appear on the surface. Many people think that this phenomenon is normal. However, if it is not improved, there will be serious consequences. In mild cases, it will cause electrochemical corrosion. In severe cases, it will cause electrochemical corrosion. It will cause many factors to have a greater impact on it. Originally, metal corrosion is a relatively complex process. If there is a problem with the copper wire in the copper stranded wire, how should it be solved?
First of all, if you want to change the situation, you should make a thorough evolution of the protective gas, and at the same time, avoid the entry of oxygen, water vapor and other harmful gases, which will cause chemical oxidation reactions. Of course, when technicians leave the air-cooling gap of the cupping furnace, they must fill the tank with protective gas. This is to keep the air pressure in the tank above atmospheric pressure.
Secondly, of course, in order to maximize the performance of the product and achieve better performance, the operator must carefully inspect and process the annealed copper wire to avoid recurrence in subsequent operations. In this kind of unexpected situation, there are usually ways to remedy the first failure of this kind of copper stranded wire. If it needs to be repaired again, it will not be just such a simple treatment.
Finally, how to accurately improve this bad situation? Of course, if the situation is serious, the damaged die must be replaced. This is also an improvement measure. It can not only effectively prevent the surface of the copper wire from being scratched due to damage to the die, even if a lot of lubricating oil remains in the scratch, thus It will cause the product to blacken, discolor, and suffer serious corrosion. At this time, the cleaning work to be done is particularly important. It must be rinsed with high-pressure water regularly, and at the same time, it must be dried and cleaned thoroughly to keep the inside of the tank clean. It is appropriate.
The contact information of Dongguan Yajie Electronic Materials Co., Ltd. is as follows:
Transparent Tinned Copper Stranded Wire Sales Department Dalian National Standard Square Copper Stranded Wire Taizhou National Standard Tinned Copper Wire Yajie specializes in the production, sales, and braided copper wire , stainless steel braided mesh, aluminum-magnesium wire braided mesh, copper-clad steel braided mesh sleeves, etc. Integrity management, excellence and reasonable prices. Welcome to call: