Capsule filling machine, semi-automatic capsule filling machine, small capsule filling machine, Qingzhou Yikang

Working principle? The editor generally adopts the form of automatic intermittent rotary motion. The rotary table is installed in the center of the workbench. Each revolution has a short dwell time. The rotary table transports the capsules to various workstations around the rotary table. During the short dwell time at each station , various operations such as capsule sowing, capsule separation, filling, waste capsule removal, capsule locking, capsule removal, and mold cleaning are automatically performed at the same time. Operating steps: Press the green button in the "power switch" to turn on the power. , slowly adjust the "vibration intensity adjustment knob" and rotate it clockwise. At this time, the sorting plate integrated with the "vibration bracket" begins to vibrate. Touch the sorting plate with your hand and adjust to a certain oscillation intensity by feeling. Put the powdered capsule shell into the "Powdered Capsule Shell Organizing Tray" and put about 3 capsules at a time. Put the capsule caps into the "Capsule Cap Organizing Tray", about 3 capsules at a time. The sorting tray is made of a plexiglass plate, with many funnel-shaped round holes drilled on it. The diameter of the round holes corresponds to the diameter of the capsule number. At this time, the capsule shell of the vibrating workbench moves forward and backward steadily, so that the capsules enter the holes of the table one by one. , about 3 seconds, the powder capsule shell and capsule cap will fall into the round hole, with the opening facing up. If some openings are facing down, you can use the capsule cap to gently press the sleeve downwards to pull it out. . Hold the powder capsule shell connecting plate in your hand horizontally (not shown in the picture, it has been prepared randomly, there is a round hole in the connecting plate), and gently push inward at the lower part of the sorting tray, and the powder capsule shell in the sorting tray will be released. Drop it down into the round hole of the connecting plate, and then take out the connecting plate. In the same way, use the capsule cap adapter to remove the capsule cap. . You can prepare in advance a square plate of medicinal powder with a bottom area of Then cover the randomly supplied plexiglass frame on the connecting plate of the powder capsule, use a small shovel to shovel the powder into the frame, scrape the edge of the frame to fill the powder, and scrape off the excess powder. . Use the randomly supplied capsule cap set plate (not shown in the picture, there are round holes on the set plate) and place it on the capsule cap connecting plate. It has alignment holes and is easy to place. Turn over the capsule cap connecting plate so that the capsule opening faces downwards, and put it on the powder-filled capsule shell connecting plate that has been filled with medicinal powder. There are also alignment holes, making it easy to fit. . Put the fitted capsule board into the cavity under the "Capsule Cap Forming Board", pull the "pressure lever" downward by hand and put it in place. There is no need to be careful about using too much force, because there is a positioning mechanism to control the pressing height. . Take out the nested capsule board, pour out the capsule, and complete filling. You can cycle to the next plate.