Tai'an Hongcheng, hydraulic door panel cold press, the bonding is stronger

Supply cold press, hydraulic cold press, woodworking cold press, ton cold press, ton cold press manufacturer direct sales technical support. Hongcheng Machinery Processing Factory in Taishan District, Tai'an City specializes in the production of cold presses, precision, edge banding machines, drilling machines, cladding machines and other woodworking machinery. It is suitable for various furniture factories and door panel factories, and can be processed and customized according to customer requirements. Technical support, top craftsmanship, welcome to the factory to visit and test the machine. The cold press is a new product produced by Hongcheng Machinery Processing Factory in Taishan District, Tai'an City. This product uses high-quality steel, fine processing, and hydraulic cold pressing machinery. Mainly used for bonding furniture panels, door panels and various panels. With good bonding quality, fast speed and high quality, it is widely used in production and processing industries such as furniture factories, suit door factories, decorative panels and composite panel factories.
Operating Procedures
1. Purchase the machinery and put it into the production site. The site should be smooth and sanitary, so that the machinery is in parallel mode.
. Open the mailbox cover and add about -kg of special hydraulic oil (based on the tank volume). (No. wear-resistant hydraulic oil)
Connect the power supply. The power supply adopts a three-phase four-wire system, and the motor rotates clockwise.
. Open the main knife, start the switch knob, and put the machine in the lifting position. Wait for a few minutes for the oil pump to remove the air and then it will automatically rise. Repeatedly manually move the knob up and down until the machine is up and down properly before it can be used normally.
Note: This product has been strictly debugged before leaving the factory. Non-professionals are not allowed to adjust any parts without authorization.