Year1
- 规格：
- 7米
- 材质：
- 不锈钢/铝合金
- 型号：
- MW047
1. Main technical indicators of the product
, effective length of roadblocks: (-adjustable)
, deflation steel nails Specifications:
Expansion (recycling) speed: /(grade road)
, remote control distance:
, working voltage:
, power supply capacity:
, continuous working time: Hours of standby time for continuous retracting and retracting operations
, Charging power supply:
, Charging time:
, Machine weight:
, Outer box size:
2. Instructions for use :
. Place the equipment box wheel facing down onto the road surface - open the locks on both sides of the traction device in the unfolding direction and turn on the power switch of the traction device (the red button lights up to indicate standby mode).
Pull out the remote control antenna - press the forward button (up button), expand the nail to the required length and release the button to stop.
When retracting, press the back button (down button) to close the nail strip and release the button to stop.
(Note: The remote control is equipped with a delay function. Master the advance amount during operation, otherwise it will cause damage due to strong inertia impact on the box)
When collecting the box, align the traction device with the interface of the nail tape box Match, then put the box upright and press the locks on both sides.
Please choose a flat road surface when laying out.
If the remote control operation is not possible due to electromechanical failure, you can hold the traction device to pull out the nail strip and complete the layout manually.
. Precautions:
Because the turning nails are sharp, be careful to avoid injury during operation and maintenance.
When laying out the spike strips, special personnel must be on duty to avoid accidental injury to pedestrians and vehicles.
During the deployment and interception, it is strictly prohibited for any person to appear within meters within the inertial direction of the intercepted vehicle and the spike belt. Avoid injuries caused by losing control of the vehicle after a tire puncture.
When the equipment is idle for a long time, it needs to be charged once every day or so.
Turn off the power switch promptly after use.
It is strictly prohibited to drop or hit the equipment box artificially or maliciously.
This product is an electromechanical product. Please pay attention to waterproofing, moisture-proof, and exposure-proof during use and storage.
When reinstalling the nail, be sure to place the rubber ring on the top of the nail shaft (nail base) first, otherwise the nail will fall off easily.
4. Judgment and maintenance of general faults:
If a remote control fault occurs, please follow the following steps:
Check whether the power supply of the remote control is normal (whether the battery of the remote control needs to be replaced).
Check whether the power supply of the equipment box is normal. (The lithium battery is charged once normally. It can be used for continuous remote control retracting and retracting for more than 10 times or continuous standby for more than 10 hours. If the equipment's working efficiency drops significantly, you should consider replacing the battery with a new one.)
Check whether the circuit board is normal (when the power is turned on, the circuit board (Whether the indicator light is on)
If the nail strip (aluminum strip) cannot be retracted and retracted normally due to deformation, please manually adjust the deformed aluminum strip to straighten it to return to normal.
The product is an electromechanical product and non-professionals are strictly prohibited from dismantling it by themselves.
5. Product completeness:
, remote control roadblock: only, remote control: only
charger: only, spare nail: only
, instruction manual: only, certificate:
Note: It needs to be charged once if it is idle for about a day.
WhatsApp
