Bosch Rexroth servo drive repair

Bosch Rexroth Servo Drive
Rr Bosch Rexroth servo drive after-sales service company, long-term inventory Rr Bosch Rexroth accessories, the company implements free detection of inverter faults, and approves maintenance costs based on alarm faults. The accessories are sufficient, the maintenance price is low, and the technology is excellent. The repair rate is low, the warranty period is long, and the service is considerate. Free on-site inspection is available. Is your trustworthy long-term partner.
Fault
, the driver overheats and shuts down. If the heat sink temperature of the driver amplifier is too high, the driver will automatically power off to prevent damage to the amplifier.
Fault,
The motor/motor overheats and shuts down. If the temperature of the motor exceeds the temperature range and reaches a temperature that the motor cannot withstand, the driver will stop working immediately.
Maintenance.3-, Maintenance.3-, Maintenance.3-, Maintenance.3-, Maintenance.3-, Maintenance.3-.
Fault
, the braking resistor is overloaded and shut down. From the mechanical inspection, it was found that the generated energy exceeded the capacity of the brake, so the drive stopped.
Fault
, the drive power supply is unstable. The voltage value of the servo motor is controlled by the driver. If the driver power supply drops to insufficient voltage to supply the driver, the amplifier will stop working.
Rexroth servo controller power supply repair, Bosch Rexroth servo power amplifier repair, Bosch Rexroth servo motor repair, Bosch Rexroth servo drive repair, second-hand Bosch Rexroth servo drive, servo Bosch Rexroth servo motor.
Our company specializes in repairing the following power controller models.
The very old models include: Rexroth power supply repair, 3 Ingimart power supply repair, Intmat power supply repair, Bosch Rexroth power controller repair, Rexroth power supply repair. Ingimart power supply repair.
Fault
There is an incorrect model number in the motor encoder. A running encoder interface has detected a hardware failure.
The cause of the fault is that the encoder cable is faulty, the encoder interface is faulty, and the driver is faulty.
If the fault is eliminated, replace the encoder cable. Replace the encoder interface. Replace the driver
Fault
, power stage overcurrent. This fault is the most common in the series. It is caused by the B module or the rectifier being burned out, and the components on the driver board being short-circuited.
Fault
, volt DC power supply failure. The driver requires control power. When this voltage exceeds or falls below this, the driver will stop working immediately.
The cause of the error is that the control voltage cable is faulty, the power supply is overloaded, or the power supply unit is faulty.
To eliminate the fault, check the control power cable and connector, and replace them if necessary.
Series YINGGIMAT servo drive/servo power controller repair center, series Bosch Rexroth servo drive/servo power drive repair