- 矿用电机车:
- cjy7
Ton electric locomotive
Ton wire electric locomotive
Technical parameters
Curb weight:
Gauge:
Traction:
Speed
Maximum traction force:.
DC voltage:
Traction motor: Taiwan
Overall length:
Overall width:
Height from rail surface to ceiling:
Traction height :
Wheelbase:
Wheelbase:
Receiver working height: ~
Minimum curve radius:
Speed regulation mode: chopper resistor
Braking Method: mechanical electric braking
Remarks: one-stage transmission
Product introduction of ton overhead electric locomotives. The new product of ton overhead electric locomotives has two power supply voltages: conical and cylindrical. The reduction box is conical and cylindrical. Double-stage gear transmission. It has the characteristics of thick body side plates, good rigidity, long service life of gears, large traction force and fast speed. Due to the use of high-precision rubber shock absorbers, it has good buffering, shock absorption, noise reduction performance and good power passing performance in small curves.
Principle of overhead wire-type electric locomotive The working process of wire-type electric locomotive. After the high-voltage alternating current is stepped down and rectified by the traction converter, the positive pole is connected to the overhead wire and the negative pole is connected to the rail. The pantograph on the locomotive is in contact with the overhead wire, introducing the current into the vehicle, and then entering the traction motor through the automatic air switch, controller, and resistance box to drive the motor to run. The electric motor drives the wheels to rotate through the transmission device, thereby pulling the train forward. The current from the electric motor flows back to the converter via the track.
: I want to purchase electric locomotives for mining. I looked around on the Internet and found that they were all about the same manufacturer. Which one is the real manufacturer?
: I know a manufacturer in Yutai, Jining, Shandong. Their products are quite good. Originally, many companies in Jining, Shandong said they were manufacturers and had the goods in stock. After passing by, they all said they were out of stock. He was the only one. They said they had the goods in stock, so I went over to see the goods. When I went there, I actually saw that the registered capital of his factory was quite large, and the certificates were all complete. I also checked them all
Contact person:
Manager Su
Mobile
Mobile:
Telephone
:
: