Linfen 013.45.1400.001 slewing bearing dealer

Linfen 3... Slewing Bearing Dealer - ! / , - During the installation process of the bearing, if the installation method or method is improper, it will cause the thrust ball bearing to be damaged on the raceway surface of the bearing during installation and disassembly. And the rolling surface causes linear scars on the bearing.
< / , -: - ! / , -The main reason for scars is that the inner ring and outer ring of the bearing are tilted during installation and disassembly of the bearing, or the impact load during installation and disassembly. This causes scars on the bearings. Therefore, in order to avoid scars on the bearings, in addition to using appropriate tools during installation or disassembly, a stamping machine must be used to prevent impact loads on the bearings, and attention must be paid to mutual centering during installation.
< / , -: - ! / , - Damage status: The so-called jamming damage is the surface damage caused by the accumulation of micro burns in the parts where the sliding surface damage occurs. Linear scars in the circumferential direction of the slide surface and rotating surface. The cycloidal scars on the roller end face are close to the jamming damage on the collar surface of the roller end face.
< / , -: - ! / , - Cause: Excessive load, excessive preload. Poor lubrication. Foreign object bites in. The inclination of the inner ring and the outer ring, and the deflection of the shaft. The accuracy of the shaft and bearing box is poor.
< / , -: - ! / , - Measure: Check the size of the payload. The preload must be appropriate. Improve lubricants and lubrication methods. Check the accuracy of the shaft and bearing box.
< / , -: - ! / , - Fracture
< / , -: - ! / , - Damage state: The so-called fracture refers to the local damage to the rib or roller angle of the raceway wheel A small part broke due to excessive impact or excessive load.
< / , -: - ! / , - Reason: It was hit during installation. The load is too large. Poor use such as falling.
< / , -: - ! / , - Measures: Improve the installation method (use hot-fitting, use appropriate tool clips). Correct load conditions. The bearings are installed in place so that the ribs are supported.