Gaowang Company electronic alcohol oil frying stove, single frying stove, double frying stove 13928895128

Electronic ignition energy-saving alcohol-based frying stove
Instruction manual
Electronic ignition energy-saving alcohol-based frying stove uses alcohol (methanol) as the main fuel. Environmentally friendly, energy-saving, powerful, smoke-free and non-toxic, it complies with national environmental protection requirements and is widely used in catering industries such as restaurants, hotels, government agencies, troops, and schools. This stove automatically ignites, and the firepower can be adjusted freely to save fuel. It also solves the safety hazard of fuel leakage in the stove core and accidental fire, and is extremely convenient to use.
1. Installation method:
,
Connect the fan power cord
,
Connect one end of the oil pipe to the oil input end of the single frying furnace, and put the other end into the oil tank.
2. Instructions for use:
,
Open the fuel tank ball valve switch to allow fuel to flow freely into the oil pipe.
,
The oil control switch needs to be turned to / (also half position), and the air valve switch in front of the panel should be turned to the middle.
Start the power, and after successful ignition, turn on the fan to the maximum, adjust the fire power, and adjust it to the required fire power for normal use.
,
When finished using, turn off the power and then close the oil valve to the middle, and finally close the damper to the middle.
,
Turn off the oil pipe ball valve switch to avoid accidental fuel leakage.
3. Solemn reminder:
,
The oil tank should be installed away from fire sources, with good air circulation, and sunlight should not be directly irradiated 1 meter higher than the stove surface.
,
Remember to stay away from fireworks when adding fuel.
After use, the oil pipe ball valve switch should be turned off, and the oil tank, pipes, and switches should be checked frequently for oil leakage.
,
There is too much oil left in the stove core, the liquid level is immersed in the ignition needle, and the oil valve is in a closed state. If you ignite first and then open the oil valve, it will cause difficulty in ignition or failure to ignite. You should use manual ignition. Drain the remaining oil in the stove core and ignite according to normal procedures.
,
High voltage will be generated when the stove core is ignited. It is forbidden to disassemble it or not perform the specified operations. Changing the use may cause accidents!