Year1
- 规格：
- 230*160*180
- 扬程：
- 9米
- 颜色：
- 白色烤漆
Power:
Lift: meters
Color: white paint
Specifications: **
Place of origin: Shenzhen, Guangdong
Water flow boosting: Increase the outlet water pressure of the pipeline to solve the problem of too small water flow caused by insufficient outlet water pressure.
Stable performance: Integrated circuit B board control, low failure rate.
Low voice: The voice is relatively quiet when working among similar products, and does not affect normal home life
Packing instructions Standard carton
Packing size**
Transportation instructions Express or automobile logistics
Delivery Instructions Delivery on arrival
Surface treatment frosted stainless steel
Material stainless steel
Product introduction:
It is recommended that those with return pipes can use water flow control and fully automatic.
The water flow means that just turn on the hot water in any place with hot water and then turn it off, and the circulating water will automatically circulate at a speed of one meter in three seconds. After the cycle is completed, turn on the hot water in any place with hot water. Hot water will come out directly.
Advantages: It is strongly recommended that wall-mounted boiler users use water flow control, because it can set short time control, which means that within a certain period of time, hot water can be used at any time.
Fully automatic means temperature control. Generally, bathing centers such as villas or hair salons can choose fully automatic mode. The so-called fully automatic, for example, sets the water heater temperature to 3 degrees, and sets the circulating water system to 3 degrees. There is a temperature control sensor probe connected to the end of the return pipe, so that once the temperature falls below 3 degrees, it will automatically start. It is started once a day, which is very wasteful. It is recommended that ordinary households do not use this function.
Note: Why can’t the above two functions be used without a return pipe?
If the water flow function does not have a return pipe, sometimes it will start when cold water is turned on. Because the water flow sensor is installed in the pump body of the water control panel, so the water pipe If the water inside fluctuates greatly, it will cause circulating water to work.
Temperature-controlled ones cannot be used, because if there is no return pipe, if the circulating water is frequently started, the cold water in the hot water pipe will be squeezed into the cold water pipe. In this way, when the cold water is turned on, hot water will also come out, so use a computer board. It is best not to debug the computer board by yourself to avoid debugging and setting the temperature control incorrectly.
If there is no return pipe, it is recommended to use a mechanical panel or a remote control panel.
The elegant manual type is the most economical and affordable, because the mechanical board has fewer components and the failure rate is definitely low.
With the remote control panel, you can directly control the circulating water system while lying on the bed, and then you can achieve the preheating effect.
Attention for solar energy users, the currently installed circulating water system of solar energy must have a return pipe. Without a return pipe, the circulation effect cannot be achieved. It is recommended not to buy blindly. Before purchasing, it is recommended to consult an expert for solutions. The solution is to add an additional return pipe. At present, manufacturers have not solved the problem of installing solar energy without a return pipe. But pressure-bearing solar energy can be used without a return pipe. The Chongqing branch has an after-sales department, so you don’t have to worry about what to do if the thermal circulating water breaks down. As long as you make an appointment and register one day in advance, an installation master will take the initiative to contact you the next day and provide after-sales service.
WhatsApp
