Twin-shaft mixer manufacturer/mortar mixer manufacturer/dry powder mixer

Twin-shaft mixer manufacturer/mortar mixer manufacturer/dry powder mixer
As the types and models of dryers on the market continue to increase, investors are even more confused about dryers. The price of dryers is the price of most investors. Important references in the process of selecting dryer equipment include whether the clutch and brake are flexible and reliable, whether the wire rope is damaged, whether the tightness of the transmission belt is appropriate, etc. It is necessary to ensure the normal operation of the main parts of the dry powder mixer, including the control mechanism, the feeding and discharging mechanism, the dry powder mixing mechanism and the transmission mechanism. If it is loose or malfunctioning, it must be repaired before use.
The surface of the steel wire rope must maintain a lubricating oil film and the silk headband must be firm. When the steel wire rope has too many broken wires or the rope strands are loose, they should be replaced. When the gap exceeds the standard, the residual material layer bonded to the drum wall and bottom will be too thick, which will increase the difficulty of cleaning and reduce the mixing efficiency. The position of the shovel blade and scraper can be adjusted by loosening the fastening bolts, and then re-tightening the bolts after proper adjustment. The gap between the shovel blade and the bottom and side wall of the cylinder can be adjusted by the position of the inner shovel blade. Generally, the distance between the shovel blade and the bottom of the cylinder is mm and the distance from the cylinder wall is mm. If the blade legs are severely damaged, they should be replaced in time. If the hopper is raised and there is no need to add material to the barrel, the hopper can be lowered into the pit again. The inspection of the transmission system of the putty powder mixer is mainly to observe whether the forward and reverse rotation of the mixing barrel is stable, and whether it is stable when changing the direction of rotation. Impact, whether there is noise from the motor brake reducer, whether the temperature rise is normal, etc. The inspection can be carried out without load, and the mixing cone can be rotated forward and reverse, with a cycle of two minutes and repeated for fifteen minutes. It can only work if all parts are normal.