Supply Pute cable float level switch Beijing cable float level switch

Cable float level switch Beijing cable float level switch Cable float level switch manufacturer Cable float level switch price Cable float level switch Content introduction:
Cables produced by Beijing Pute Instrument Complete Factory The float level switch is designed using the principles of gravity and buoyancy. The structure is simple and reasonable. It mainly includes a large-capacity micro switch set in the float body, a driving mechanism that can put the switch in an on-off state, and a three-core cable connected to the switch. . The notable feature of this product is its stable and reliable performance (no malfunction caused by fluctuations in liquid level). It is also non-toxic, corrosion-resistant, easy to install, low-priced, and has a long service life.
This product can be matched with various liquid pumps and widely used for automatic control of water supply, drainage and corrosive liquid level.
2. Product usage description
Simple structure and reliable performance: The product can send out switch control signals under normal circumstances, with strong reliability and strong anti-interference.
Sturdy and durable: the product has long service life and low failure rate when operated correctly.
Easy installation method and convenient adjustment method: The water level control range can be installed by using a screw to protect the cable signal.
Wide range of applications and strong general performance: This product is suitable for diesel engine gasification and automatic fuel supply in non-polluting environments such as tributary sewage, oil, and acid liquids with a concentration less than the medium concentration (such as the food and beverage industry).
The circuit is simple, economical and practical: the operating voltage and current product application circuit is simple and low in cost.
3. Wiring method
Use black and blue wires:
The contact is connected when the float is at the water level
The contact is disconnected when the float is at the water level
Use black and brown wires:
The contact is connected when the float is at the water level
The contact is disconnected when the float is at the water level
4. Heavy hammer Installation method
. Pass the wire of the float switch through the concave round hole in the center of the weight and gently push the weight to make the plastic ring embedded above the round hole fall off due to the push of the wire head. (If necessary, you can also use a screwdriver to remove a plastic ring.) Then put a weight on the cable covered by the fallen plastic ring to set the water level where you want.
.Gently push the weight to pull out the cable until the center of the weight catches the plastic ring. As long as the weight is gently buckled into the plastic ring, it will not slip off. If the plastic ring is damaged or lost, it can be replaced with a light bare copper wire buckled into the cable.
The weight is an accessory only upon request
Please pull the wire directly to the control box and try to avoid using intermediate connectors. If you have to, never immerse the cable connector in water when there is a connector.