Shandong stove manufacturers supply various alcohol-based fuel stoves and alcohol-based fuel stoves.

两炒一溫：

850*1800

The use of alcohol-based fuel burners requires regular maintenance. Reasonable maintenance can extend its service life. First, let's understand how to maintain and maintain alcohol-based fuel burners. It is best to clean the alcohol-based fuel burner immediately after each use. The most important thing is to wipe off the fine sand on all the screw teeth because it will wear the screw teeth. In addition, it is also necessary to clean the carbon stains on the nozzle and wipe all metal components to prevent oxidation.
The alcohol-based fuel burner should be disassembled for comprehensive cleaning and inspection at regular long intervals, such as after more than ten uses or every two or three years. For example, clean the inside and outside of the nozzle and the carbon stains on the fuel pipe, and check whether the rings of all interfaces are aging and hardening, etc. At the same time, add lubricating oil to all moving parts. For example, in a liquid pressure furnace, check the steam pump and pull the pump wide and scrape off all rust
Alcohol-based fuel stoves change the traditional emission method and change the exhaust gas emission to exhaust gas. The harmful components become a soluble solid and are discharged in the furnace. The combustion of any fuel will produce harmful gases such as sulfur dioxide and carbon monoxide. Methanol, especially primary alcohol and waste alcohol recovery, contains many chemical raw materials that are harmful to the human body or the environment. If they are emitted in the form of gas, it will be very harmful to the human body and the environment. The alcohol-based fuel heat stabilizer turns the harmful components in the exhaust gas into a soluble solid that is discharged in the furnace. When the furnace of the alcohol-based fuel stove is used during the day, the temperature can reach several hundred degrees. At night, when the temperature drops to room temperature, the furnace will A large amount of water vapor is formed. The soluble solids produced will dissolve in the water vapor and be absorbed by the dry environment in the furnace. This is why the furnace will have a little white matter after use. The white matter will disappear the next day. There is water on the inner wall of the furnace core. The reason for beads.