Xinyue metal crusher scrap steel crusher has excellent performance and excellent quality

Metal crusher is a professional machine that crushes large-sized solid metal materials to the required size. According to the size of the crushed materials or crushed materials, the crushers can be divided into coarse crushers, medium crushers, fine grinders and ultra-fine grinders. This machine is mainly composed of worm gear reduction motor, casing, frame, combined spiral tooth cutterhead, driving shaft, driven shaft, large gear, small gear and other parts. There are four external forces exerted on solids during the crushing process: rolling, shearing, impact, and grinding. Rolling is mainly used for coarse and medium crushing. It is suitable for the crushing of hard materials and large materials. Shearing is mainly used for fine crushing. It is suitable for the crushing of tough materials. Impact is mainly used for medium crushing, fine grinding and ultra-fine grinding. It is suitable for the crushing of brittle materials. The grinding is mainly fine grinding, and ultra-fine grinding is suitable for crushing small pieces and fine particles. The actual crushing process is often caused by several external forces acting at the same time.
Metal crushers can be roughly divided into three types according to their working principles: 1. It uses a double-shaft or single-shaft low-speed rotation to use a cutterhead to cut, cut, tear and pull the material. The gear speed is transmitted to the driven shaft so that the movable cutter of the driving shaft and the stationary cutterhead on the housing form relative motion. The staggered arrangement of the spiral toothed cutters on the driving shaft causes the material to be squeezed, torn and sheared at the same time after entering, thereby crushing the material. Two: Use the high-speed rotating impeller to tear and break long metal chips. Multiple circular steel plates are connected in series on the main shaft that rotates at high speed (approximately rpm). The circular plates rotate in conjunction with the main shaft. The circular plate is surrounded by small gears made of manganese steel. The pinion rotates freely on its own axis. The long and messy metal chips enter the machine from the top port and are twisted by the gears on the steel plate that rotate at high speed and are torn into small pieces. They flow out from the sieve hole at the bottom. The size of the sieve hole can be selected according to the size of the broken particles required for the metal chips. Certainly.
The metal crusher uses the basic principle of extrusion driven by the motor to drive the wind wheel. Driven by the high-speed and high-torque motor, the crushed materials can be fully and effectively crushed in the crushing chamber, and the materials to be crushed are torn into broken materials that meet the specifications. . The crushed materials are separated from paint buckets and non-paint buckets through an air gyration sorting system, and the entire system is equipped with a dust removal device to minimize the hazards of dust pollution generated during the production process. This equipment mainly has the advantages of high output, low energy consumption, high efficiency, and uniform discharging and fine crushing. And when using this equipment, it has low noise, no pollution, simple operation and convenient maintenance.
The reduction motor adopts a direct-connected worm gear reduction motor, which is directly installed on the driving shaft of the pulverizer and transmits the speed to the driven shaft through large and small gears, so that the helical cutterheads on the main and driven shafts form relative motion. The staggered arrangement of the spiral toothed cutters on the main and driven shafts causes the materials to be squeezed, torn and sheared at the same time after entering, thereby crushing the materials. Since most of the metal materials that need to be broken are brittle and hard, the internal parts of the chip breaker, the pinion, the iron screen, and the like must be made of wear-resistant hard material, Taijin steel. A flywheel is installed on the main shaft so that the main shaft has greater torque when breaking iron chips. In addition, it is best to use a fluid coupling to drive the spindle to eliminate the excessive peak current of the motor and absorb the vibration of the spindle. When the shearing machine is used to break turning chips of highly wear-resistant materials (such as bearing iron chips), the rotor must also be surface-coated and welded to enhance its wear resistance.