Fun little people pull cars, spin airplanes, and robots pedal cars

Installation Instructions for Robot Pulling Cars
-:..Installation Instructions for Robot Pulling Cars. After receiving the goods, open all the things inside. Each car has a number written on the motor, and a number written on the seat. There is also a number on the seat. When installing the vehicle, first assemble the corresponding legs of the robot and the frame. When installing, remove the screws in the middle and install the two iron plates in the middle of the robot legs on the iron plates on the frame (the iron plates on the frame should be clamped Then just fix the screws in the middle of the iron plate of the robot.) To install the seat, first install a backrest plate behind the frame and fix it with three screws. Lean the armrests on both sides against the backrest plate and take it out from the tribute wire. Just tighten it. To install the shed, insert the two rods at the back directly onto the welded ring on the frame, and then insert the shed directly into it. Handlebar installation: Install the black handlebars on the screw rods on both sides of the robot and tighten the screws
-..Bumper car
-.
-..Rated voltage< volt rated load < Jin (the rated load capacity is a conservative numerical test< Jin is no problem)
Robot Pull Truck Installation Instructions
-:.. Robot Pull Truck Installation Instructions After receiving the goods, open everything inside Each car has a number written on the motor. There is also a number written on the seat. To install the car, first put the corresponding legs of the robot and the frame together. When installing, remove the screws in the middle and remove the two middle pieces of the robot legs. The iron plate is installed on the iron plate on the frame (the iron piece on the frame should be sandwiched between the iron plates of the robot and then fixed with screws). To install the seat, first install a backrest plate behind the frame. Fix the three screws and place the armrests on both sides against the backrest board. Use the Zigong wire to tighten them. Install the shed. Insert the two rods at the back directly onto the welded ring on the frame and then insert the shed directly. Just go inside. Handlebar installation: Install the black handlebars on the screw rods on both sides of the robot and tighten the screws
-..Bumper car
-.
-..Rated voltage< volt rated load < Jin (the rated load capacity is a conservative numerical test< Jin is no problem)
-.