Highly efficient photocatalyst nano titanium dioxide

High-efficiency photocatalyst R Nano-titanium dioxide properties:
The particle size is very small: the particle size is smaller than nanometers and does not agglomerate.
Good dispersion performance: This nanometer titanium dioxide has very good dispersion performance. Put it into water and shake it gently, and it will immediately melt into a transparent liquid without stirring. It can be sprayed onto furniture surfaces and walls to form a uniform and transparent nano-coating, which can purify indoor air.
High catalytic activity: The catalytic activity of this nanometer titanium dioxide has been tested and compared, and it is several times higher than the catalytic activity of all the nanometer titanium dioxide with the best catalytic performance currently on the market. It can quickly capture and decompose indoor formaldehyde, benzene, ammonia and other harmful gases, and has a good deodorizing effect.
Technical indicators:
Instructions for use: Use distilled water, deionized water, etc. to make R powder into an aqueous solution with a solid content of %, and spray it on walls and ceilings. It requires good atomization effect and no water droplets. Formaldehyde indicators and odor indicators can meet the standards within hours. If the smell is strong, you can spray it twice more. (It is recommended to use a clean towel dipped in water to gently and evenly wipe the inside and outside of the furniture. The first towel should be wet, and the second towel should be dry. The same is true for the floor, or use a clean mop to mop evenly)
Note Matters:
It is generally recommended to wipe the inside and outside of the furniture with a good quality towel soaked in water (the concentration of the aqueous solution is %). It is recommended not to spray on the metal surface
. Start ventilating after spraying. If there is a lot of indoor furniture , formaldehyde evaporates faster and has a higher concentration. It is recommended to spray it several times to increase the degradation rate.
When spraying, generally use a paint spray bottle, which has a good atomization effect, which will spray more evenly and improve efficiency.
Before spraying, clean the surface to be painted, cover the objects that are not suitable for spraying, and keep the distance between the spray bottle and the object to be painted.
The natural drying time of the coating film is about minutes, and it takes hours to fully cure. Do not scrub vigorously before it is completely cured.
When used for sewage treatment, first dissolve R with a small amount of pure water, and then add it to the sewage. It is recommended to take the water behind the secondary sedimentation tank and in front of the biochemical tank. The water with better transparency will have more obvious treatment effect. It is more suitable to treat the sewage after inorganic sedimentation treatment. The dosage is about R powder for one cubic meter of sewage.
Packing bag or/barrel.