Hydraulic cold press, the largest production base in the country

The cold press is a new product developed and produced by Tai'an Hongcheng Machinery Processing Factory. This product uses high-quality steel, fine processing, and hydraulic cold pressing machinery. Mainly used for bonding furniture panels, door panels and various panels. With good bonding quality, fast speed and high quality, it is widely used in production and processing industries such as furniture factories, suit door factories, decorative panels and composite panel factories. Operating Procedures
Purchase the machinery into the production site, make the site smooth and sanitary, and keep the machinery in parallel mode.
. Open the mailbox cover and add about kilograms of special hydraulic oil (% of the tank volume). (No. wear-resistant hydraulic oil)
, connect the power supply. The power supply adopts a three-phase four-wire system, and the motor rotates clockwise.
. Open the main knife, start the switch knob, and put the machine in the lifting position. Wait for a few minutes for the oil pump to remove the air and then it will automatically rise. Repeatedly manually move the knob up and down until the machine is up and down properly before it can be used normally.
Note: This product has been strictly debugged before leaving the factory. Non-professionals are not allowed to adjust any parts without authorization.