TF-530 desktop enameled wire paint grinding machine, Dongguan induction cooker glue injection machine manufacturer

Model high-performance enameled wire paint grinding machine adopts the latest full-contact conical grinding wheel designed in the United States, which has remarkable effects. It can completely remove any hard insulating paint, enamel paint, etc. on the wire surface without damaging the copper wire itself. Suitable for wire diameter range (?), suitable for smaller thin wires, and can process multiple strands of enameled wire at the same time. Easy to operate, excellent effect. Specifications
Applicable wire diameter (.~.)
Machine size
Operating voltage/ .
Machine weight
Installation and use
According to the grinding wheel specifications in the table, install the appropriate grinding wheel on the machine, with the tapered part of the grinding wheel upward, and place an enameled wire on In the middle of the two grinding wheels, adjust the two grinding wheels until the enameled wire is lightly clamped. Hold the coil part with your hand and turn on the switch to test the paint removal effect. You can adjust the pressure of the contact surfaces between the grinding wheels to achieve the ideal control. The paint removal effect is better.
When working, put the enameled wire into the top between the two grinding wheels, and then pull the enameled wire out from the bottom of the grinding wheel easily from top to bottom. The paint removal work is completed, because when the machine is running, the fiber grinding wheel is at high speed. Rotate to remove the insulating paint or oxides of the enameled wire. After the paint is removed, the surface of the enameled wire and copper wire is bright and clean. A single enameled wire has a better paint removal effect.
When the surface of the grinding wheel is uneven or concave and convex during operation, it will cause wire breakage and paint peeling off. At this time, the grinding wheel needs to be trimmed. You can use emery cloth to trim and smooth the tapered part of the grinding wheel until both sides are smooth. The conical part of the grinding wheel can be in flat contact with the grinding wheel during regular dressing work, which can increase the service life of the grinding wheel.
The cone-shaped grinding wheel can use the collar on the shaft to move the grinding wheel upward until it wears to the bottom of the entire grinding mill. For the convenience of operation, the inner hole of the grinding wheel is directly installed on the shaft. Therefore, when it is necessary to replace the grinding wheel with a new one, just pull out the unusable grinding wheel from the shaft and insert the new grinding wheel to start working again.