500×8 rubber waterstop | 300×10 rubber waterstop

The rubber waterstop is a new improvement based on the traditional waterstop. The rubber waterstop can use the high elasticity and compression deformation characteristics of the rubber itself to produce elastic deformation under various loads, thereby playing a role Effectively tighten and seal to prevent water leakage, water seepage and shock absorption and buffering in the building structure, thereby improving the waterproof safety factor of construction/expansion joints. If leakage occurs, it can be repaired effectively and quickly through grouting. The waterproofing quality is reliable and will not recur. Its comprehensive cost is the most economical, completely solving the weaknesses of traditional waterstops. The rubber waterstop produced by our factory is a new type of waterstop product. It adopts advanced waterproofing concepts and is widely used in the construction of construction joints and deformation joints, bridge expansion joints, and is a waterstop that can be detected and repaired by grouting. This product can be applied to the construction of all underground waterproofing and drainage structures, such as retaining dams, reservoirs, subway tunnels, basements, etc. Rubber waterstop products are made of domestic Yunnan natural rubber and imported synthetic rubber as the main raw materials, and are mixed with various additives and fillers. After plasticizing, mixing, and pressing, the waterstops produced are of various specifications. There are many types of rubber waterstop products, including bridge type, mountain type, type, type, type, type B, type, type, type, type, type, etc. .According to the usage in the project, it can be classified into buried rubber waterstop and back-attached rubber waterstop. The material has good elasticity, wear resistance, aging resistance and tear resistance, strong adaptability to deformation, and good waterproof performance. The temperature range is ℃ + ℃. When the temperature exceeds ℃, and is subject to strong oxidation or Rubber waterstops are not allowed to be used when corroded by organic solvents such as oil. The scope of application is applied to the waterproofing of deformation joints in underground structures, dams, reservoirs, swimming pools, roofs and other building materials and structures
In rubber waterstops During the product design process, the following factors should be taken into consideration. The product should be easy to install and maintain its position. The waterstop should be tightly and reliably combined with the concrete. The construction quality of the completed waterstop should be inspected. If there is a problem due to the quality of the waterstop or construction quality, etc. For reasons that cause water seepage in construction joints, a second waterproof line of defense should be set up to enable the fastest, most economical and most effective repair, and the waterproof quality after repair is reliable and durable.