SMC optical cable transfer box floor-standing optical cable transfer box jumper-free optical cable transfer box

The optical cable transfer box is an interface device used to connect outdoor trunk optical cables and distribution optical cables. It can realize the functions of direct connection and cross connection of optical fiber splicing and wiring. ? The integrated pump-out module is adopted to make the transfer box have large capacity and high density.
? The box is made of high-strength polyester box and has an optical cable transfer box. It is a device that implements outdoor optical fiber distribution at the node of the trunk optical cable and distribution optical cable in the outdoor optical cable access network. It has good corrosion resistance and aging resistance. , can withstand severe climate changes and adapt to harsh working environments.
? The box has good sealing performance and the protection level reaches / level.
? It has good installation performance and anti-vandal function.
? The cabinet has safe and reliable optical cable fixing and grounding protection devices.
? The material of the optical cable transfer box is, capacity ~ core.
Technical Characteristics
? Insulation resistance between high-voltage protective grounding and chassis/
? No voltage breakdown or arcing between the high-voltage protective grounding and chassis.
? Static load capacity of the box cover, side surface, door hinge
? The sealing protection level of the chassis reaches the standard intermediate level
Working environment
? Ambient temperature ℃～ ℃
? Relative humidity is less than % at ℃
? Atmospheric pressure ~
2. Features
※Suitable for a variety of usage scenarios indoors, outdoors, wall-mounted, pole-mounted, new and old buildings.
※Molded box body, mounting back panel design, beautiful and compact appearance, convenient and quick installation, convenient for large-scale construction.
※ The splitter module port has an inclined design and the routing is smooth.
※Serialized inserts can be combined in building blocks, which facilitates capacity expansion and saves investment.
※The leather optical cable adopts a special card slot design, which can be put into the box with a loose joint, which is reliable in fixing and easy to lay out with high efficiency.
※Factory-based fiber pigtails realize high-quality, low-cost and rapid deployment.
Distribution optical cable welding
. To facilitate welding, the box can be removed, or the splicing tray can be removed separately
. Pull the splitter module rotating frame upwards to take out the box. And remove the optical cable threading slider and place it properly
. Strip the optical cable, wrap a few turns of insulating tape around the stripping part of the optical cable, and then tighten it with a hose clamp
. Weld the distribution optical cable, press The figure is coiled. After the operation is completed, insert the module rotating frame into the hinge rotating shaft
. Insert the spliced pigtail connector into the splitter input port. If it is not activated temporarily, park it in the parking area
. Carry out Ground the reinforced core of the optical cable and lead the ground wire from the optical cable entrance to the ground
. Fix the optical cable threading slider and reinstall the box on the wall back panel