AT special adhesive for ceramic tiles

Special adhesive for ceramic tiles
> r
>Product
Introduction
>Special adhesive for ceramic tiles uses imported dry powder polymers, high-quality cement, fine aggregates, fillers and other raw materials , scientifically compounded into a special adhesive for ceramic tiles. This product is a green and environmentally friendly product, non-toxic and harmless. Compared with traditional cement mortar, it is safer and stronger, and has excellent waterproof performance. It can be used for pasting ceramic tiles and indoor floors and walls to be waterproof and impermeable.
>Technical indicators
Comply with the standard of "Ceramic Wall and Floor Tile Adhesives"
< > < > Project

> Indicators


< > Appearance

> Gray powder


< > Tensile bonding strength

>


< > Tensile bond strength after water immersion

>


< > Tensile bond strength after heat aging
/>
>


< > Tensile bond strength after freeze-thaw cycles

>


< > Cooling time: Tensile bonding strength

>, at least after



> Main features
> Sticky It has strong knot strength and a certain degree of flexibility, completely eliminating problems such as peeling, hollowing, and cracking.
>Good durability, good alkali resistance, freeze-thaw resistance and stability.
>Construction is convenient. The powder is packed in bags and can be constructed by adding water and stirring on site.
>Mineral materials, green and environmentally friendly without any radiation and pollution.
>Good operating performance, good water retention and anti-sag properties, and excellent waterproof and anti-permeability properties.
>Scope of application
>Suitable for pasting various ceramic tiles, marble, granite and mosaics on indoor and outdoor floors and walls.
>Construction Technology
> Base layer treatment: The base layer must be clean, flat and dry, with no looseness on the surface.
>Ingredients: Water consumption: Water needs to be added to packaging materials. Put the measured water into an appropriate container, start the mixer and add the powder at the same time, and stir until the material is free of granular materials.
>Construction: Use a putty knife to apply the mixed clay on the construction base, spread it evenly with a suitable toothed scraper, and comb it into stripes, and then paste the ceramic tiles or other surface materials.
>Reference dosage
>It varies according to the specific conditions of the base surface. The flatter the base surface, the less the slurry dosage. Use a toothed scraper for approx.
>Notes
>Construction temperature is ℃
.
>Do not mix the dried adhesive with water before use.
>Prevent rain and frost within hours after construction.
>Packaging
>/bag, moisture-proof paper bag packaging.
>Transportation and Storage
>During transportation and storage, the packaging should be protected from rain and moisture to keep the packaging intact. The shelf life of unopened packaging is one month.
>
>