4 ton three wheel crane, 4 ton crane, three wheel crane

型号：

4吨三轮车吊车

Ton Tricycle Crane
Introduction The Ton Tricycle Crane is a miniature crane mounted on an agricultural tricycle. It has a lifting capacity of tons and a lifting height of up to fifteen meters. It is an economical and practical small crane. The three-wheeled crane with ton capacity can be used in small projects. In places where large vehicles cannot enter or are difficult to walk, the tricycle crane is more portable and flexible
Small crane with ton capacity and small crane configuration
Model
Ton
Lifting speed
/
Maximum lifting height
m
Swing speed
./
Maximum lifting weight
Tons
Driving speed
/
Engine model
Shifeng
Tires
Power distribution motor
(kW)
Overall dimensions< br/>Length, width and height (can be extended to meters)
Chassis
Shifeng Huaqing three-wheeler
Working oil circuit
Problems that need to be solved during the installation process of ton three-wheel crane< br/> In order to ensure the ground clearance after the installation of the small crane, the connection between the rear part of the engine and the transmission input shaft should be appropriately raised, and the front and rear connecting brackets should be thickened respectively. The water inlet of the radiator is at the upper part. One on the left and one on the left, respectively, connected to the water outlet pipes of the cylinder heads on the left and right sides of the engine. The water inlet of the radiator is in the middle of the upper part. There is only one, which is connected to the water outlet pipes of the cylinder heads on both sides through the thermostatic device in the middle. Among them, because the small crane radiator is installed at the lower part of the cab, the connection method and fixing device are not easy to change, so it is very difficult to replace the radiator. Use the original radiator. Notice that the original radiator is convenient for replenishing cooling water. There is a water inlet in the middle of the upper part, which is led out through a section of water adding pipe. This inlet can be used as a water inlet, connected to the water outlet of the engine, and one of the two original water inlets can be sealed. The other one is led out with a section of water pipe to replenish cooling water. The location of the water outlet pipe is the same, at the bottom, without any modification.
Jining Zhongrui Contact Information
Telephone