SH5041XDWA2D5 Chase Tool Service Truck

& Maxus Tool Service Vehicle
This car is modified by SAIC Maxus. SAIC Maxus adopts Italian engine technology, with an output power of up to 100 horsepower and a fuel consumption of 100 kilometers at constant speed. It has been fully upgraded to the National V standard and can provide National V and National IV models according to customer needs. The third generation high-pressure common rail fuel injection system, cylinder valve, and fuel pressure up to Br, provide more complete combustion, greater power, lower fuel consumption, lower emissions, and constant speed fuel consumption per 100 kilometers as low as...
SAIC Maxus has the highest space utilization rate among similar products (% higher than similar products), and the height inside the car is high, allowing you to stand upright in the car. Integrated, cage-frame structure fully load-bearing body, European safety crash design standards, high strength and light weight. At the same time, the key parts of the car body are made of ultra-high-strength steel, with a dosage of up to %, while similar products only use about %.
&B+B+B+ and four-wheel disc brakes effectively improve driving stability.
Configuration:
, left and right lift-up doors, front partition (skeleton structure, small pattern aluminum plate in the rear cabin, front soft package), middle partition (skeleton structure, small pattern aluminum plate), rear partition ( Muscle structure, small patterned aluminum plate in the rear cabin, with a pull-out display cabinet device in the middle and sealed on all sides), floor (large patterned aluminum plate), left and right display panels (shaped structure, the ribbed structure is covered with small patterned aluminum plate), drawers (left and right upper lift doors One group each), rear display cabinet (skeleton structure, patterned aluminum plate, left and right pull-outs, customized drawer guides), indoor lighting (energy-saving lamps, two in each display cabinet, two in the middle), switch
Parameters:
Model

:
Brand
:
Datong
Type
:
Mobile service vehicle
/>Total mass
:
Curb weight

:

Fuel type
:
Diesel
Emission basis Standard
:
B country V,
Axle number
:
Axle base
:
Axle load
:
/
Number of springs
:
/,/

Number of tires

:
Tire specifications
：
/R

Close to departure angle
：
/,/
Front overhang and rear overhang
：
/, /
Front track
:
Rear track
:
Vehicle
Size:
,


Maximum speed
:
Rated passenger capacity

:
Chassis
:
Engine model
:
.
Displacement
:
Power
:
.
Contact information:,
Jiangsu Hongyun Automobile Technology Co., Ltd.
No. Zifeng Road, Pukou Economic Development Zone, Nanjing