P100-A3-FR-01 plunger pump HPC Xuhong oil pump

型号：

P100-A3-F-R-01

材料：

铸铁

原理：

柱塞泵

HTaiwan Xuhong pressure compensation control type plunger pump RRRR
RRRR
RRRR
RRRR
RRRR
RRR.
RRR.
Instructions for use
Variable piston pump~The pressure and rotation number of the pump should be used within the specification range. The selected quality hydraulic oil should meet the standard and its viscosity range should be within/and wear resistance is usually the best. The most appropriate viscosity when the pump is running is /.
Variable piston pump Variable piston pump ~ The hydraulic oil temperature range used is ℃. When the hydraulic oil temperature is in the following situations, the hydraulic oil should be heated at low speed and low pressure until the oil temperature rises to ℃ before it can be officially operated.
The variable piston pump should be used when the suction inlet pressure is at the maximum discharge flow rate and the flow rate is above / and within /.
Variable piston pump ~ The centerline error of the pump axis and drive axis shall not be greater than . The gap angle shall be within ℃.
Variable piston pump ~ Please install an oil filter at the suction end. The mesh size should be below h. The filtration value is below h. If you need to extend the life of the pump, you can install a magnetic filter or an oil filter with a filtration value below h. (/When using the above high pressure, it is recommended that the filtration value below be the most appropriate).
Variable piston pump~Hydraulic oil should avoid the penetration of foreign matter such as metal powder and water, which will deteriorate the oil quality and shorten the life of the pump. Pay full attention to the oil quality and ensure that the pollution degree is below grade.
Variable piston pump~The pump drain port should be facing upward. The drain pipe must be directed to the tank. The drain pipe must not be connected to any other return pipe. The end of the drain pipe must be below the lowest liquid level in the tank and as far away from the pump suction as possible. The drain port pressure should be less than /. Mainly used for mechanical hydraulic accessories such as packaging machinery, injection molding machinery, rubber machinery, hydraulic machinery, die-casting machinery, plastic machinery, engineering machinery, machine tool machinery, mining machinery, forging machinery, fluidization machinery, hot pressing machinery, shoemaking machinery, ceramic machinery, brick-making machinery, foaming machinery, stretching machinery, etc.