Product Details
', , h >Hebei Tianze Pipeline Co., Ltd. is a large anti-corrosion steel pipe manufacturer in Hebei. Our factory specializes in the production of three-layer anti-corrosion steel pipes for natural gas and three-layer reinforced anti-corrosion steel pipes. Our factory provides high-quality seamless steel pipes and straight-seam steel pipes. , spiral steel pipes, processed into three-layer anti-corrosion seamless steel pipes, three-layer anti-corrosion straight seam steel pipes, three-layer anti-corrosion spiral steel pipes, three-layer anti-corrosion steel pipes for gas pipelines. Our factory has a large number of pipes all year round, welcome to negotiate.
In response to the domestic debate over the use of coatings, China Petroleum Engineering Technology Research Institute was commissioned by Beijing Huayou Natural Gas Co., Ltd. to complete the "Shaanxi-Beijing Gas Pipeline Outer Research on safety evaluation of polyethylene coating of anti-corrosion layer structural system. The research includes collection from foreign literature, analysis of the results of excavation inspections and non-excavation inspections of pipeline outer anti-corrosion layers conducted by Beijing Huayou Natural Gas Co., Ltd., and analysis of the results of unused Shaanxi-Beijing pipelines stacked in the open at the North China Petroleum Steel Pipe Factory and After years of anti-corrosion performance testing, the following conclusions were drawn
At present, the application effect of the anti-corrosion layer at home and abroad is very good, and there are few reports of defects caused by its use. The main reported shortcomings include dew point, peeling, cathodic peeling, cathodic protection shielding, peeling and corrosion under the anti-corrosion layer, etc., and most reports of defects still remain in the theoretical speculation stage. For example, the problem of cathodic protection shielding is mentioned in the data. There have been no reported instances of cathodic protection shielding occurring during actual operation of the anti-corrosion layer. Years of practice have shown that as the service life increases, the coating system with the fewest defects is the extruded polyethylene layer structural anti-corrosion system.
Through a review of the annual application history of polyethylene anti-corrosion layers in Europe, although corrosion or stress corrosion cracking will theoretically occur under the peeled anti-corrosion layer, it has not yet occurred. Cases of subfilm corrosion or stress cracking under peeled anti-corrosion layers. At the Mannesmann Institute in Germany, long-term corrosion laboratory experiments have been conducted to simulate the effect of anti-corrosion layer application. The corrosion experiment environment includes soil and water. The test mainly examines the problem of stress corrosion cracking. The experimental anti-corrosion is to place the defective polyethylene anti-corrosion layer steel pipe under corrosion conditions and stress conditions. The corrosion environment is a sandy soil environment containing H, and the temperature is ℃. The pipe-to-ground potential is ~m, the surface of the steel pipes is pretreated in different ways, and all steel pipes are circulated under pressure. At the end of the experiment, there was more or less peeling around the defects in the anti-corrosion layer, but no corrosion was found in the peeling area. Steel pipes without oxygen scale on the surface are prone to stress cracking. Steel pipes with oxide scale are cracked. The maximum depth of the crack is m, which may be caused by stress corrosion. It is concluded that thorough surface preparation is an effective means of preventing stress cracking.
The Shaanxi-Beijing Pipeline excavates m-long pipe sections every year, and the anti-corrosion layer has four damage points. It can be seen from the defective form of oil damage points that the damage to the anti-corrosion layer is caused by scratches by hard objects. After inspecting the pits of straight pipes and cold-bent pipes, the peel strength was detected in total. The peel strength value was lower than /m, the minimum peel strength/m, and the maximum peel strength/m. The reason is that the Shaanxi-Beijing pipeline is the first to adopt coating technology in China. The coating level of the coating company is limited and the control ability of the process engineering is relatively poor. This may lead to improper setting of the coating process of individual pipelines, resulting in the adhesion of the anti-corrosion layer. Poor strength. The peeling strength of the anti-corrosion layer is low only in certain parts, and as long as the anti-corrosion layer is not damaged, it will not cause pipeline corrosion.
Random tests were conducted on the remaining anti-corrosion pipes of the Shaanxi-Beijing pipeline stored in the open air at the North China Petroleum Steel Pipe Factory in 2011 and 2016. The results showed that their anti-corrosion performance has not declined at all, especially for Hualong Company. The anti-corrosion pipes produced by Qilu polyethylene still meet the current standards/regulations after years of storage, indicating that the anti-corrosion layer does have excellent durability and anti-aging properties.
Disclaimer
The information/pictures/parameters, etc. displayed on this webpage about【Three-layer PE anti-corrosion steel pipe manufacturer】are provided by member【Hebei Tianze Pipeline
】，By Titker Trade Network members 【Hebei Tianze Pipeline
】is solely responsible for the authenticity, accuracy and legality of the information/pictures/parameters, etc.，Titker Trade Network only provides display services. For your safety, please choose Titker Trade Network for online trading, otherwise Titker Trade Network will not bear any responsibility for this.
If your legitimate rights and interests have been infringed, please contact Titker Trade Network customer service as soon as possible. We will serve you wholeheartedly. Thank you for your attention and support to Titker Trade Network!
Year1
Business card
WhatsApp
