Shuguang analyzes several reasons for the discharge of dry powder mixer

>Shuguang analyzes several reasons why the dry powder mixer pours materials
>
Today, Zhengzhou Shuguang Mixer Factory analyzes several reasons why the dry powder mixer pours materials. I hope it will be helpful to everyone. First of all Discharging is related to process configuration. The raw materials for batching directly enter the primary mixing cylinder through the belt, and are in direct contact with the inner wall of the cylinder. Long-term cementation causes the raw materials entering the cylinder to agglomerate and form circles at the discharge point in the primary mixing cylinder, causing material dumping. There is also something to do with the particle size and type of raw materials. Due to the strong adhesion of hydrated lime, the polymer wear-resistant lining plate is basically covered by adhesive agglomerates, and the lifting plate and ball-making plate have little effect.
>
There is also something related to the selection of the mixer. After the mixture enters the cylinder, due to the friction between the material and the cylinder wall, it adheres to the cylinder wall and rises to a certain height. The sintering machine Production capacity will also be greatly affected. Therefore, in view of the different design characteristics of the mixing system and the current common domestic raw material conditions, it is necessary to ensure the mixing effect and no material dumping. It creates relative motion with the rising material and rolls into a ball. The mixture continues to move forward during multiple reciprocating movements. This axial movement speed is mainly related to the cylinder inclination angle, that is, the mixing and balling time is short and the effect is poor.
>
Through the above analysis of the reasons for the discharge of dry powder mixers, the solution has come out. For the discharge problem of the same type of mixer, the high-pressure water and air pressure values need to be based on the alkalinity of the raw materials and the mixing The adhesion and other conditions in the machine should be adjusted, and the characteristics of the raw materials used in the sintering plant should be taken into consideration when selecting the mixer.
>See the company website for details
>Dry powder mixer
>/Powder mixer
>Contact Manager Zhao
Mobile phone