High catalytic activity nano titanium dioxide efficient photocatalyst JR05

High catalytic activity nanometer titanium dioxide and efficient photocatalyst
Basic information
Contact person Li Mei
Properties
The particle size is very small, the particle size is smaller than nanometers, and it does not agglomerate.
Good dispersion performance This nanometer titanium dioxide has very good dispersion performance. Put it into water and shake it gently, and it will immediately melt into a transparent liquid without stirring. It can be sprayed onto furniture surfaces and walls to form a uniform and transparent nano-coating, which can purify indoor air.
High catalytic activity. The catalytic activity of this nanometer titanium dioxide has been tested and compared. It is 10 times higher than the catalytic activity of all the nanometer titanium dioxide with the best catalytic performance currently on the market. It can quickly capture and decompose indoor formaldehyde, benzene, ammonia and other harmful gases, and has a good deodorizing effect.
Technical indicators
Project

Indicators

Model



Powder appearance
/>
White powder

Appearance of powder dissolved in water

Transparent liquid

Particle size



Purity



Surface properties

Hydrophilicity

How to use the powder Use distilled water, deionized water, etc. to make an aqueous solution with a solid content of 0.0, and spray it on the walls and ceilings. It is required that the atomization effect is good, and the formaldehyde index and odor index can meet the standards within hours when no water droplets appear. If the smell is strong, you can spray it twice more. (It is recommended to use a clean towel dipped in water to gently and evenly wipe the inside and outside of the furniture. The first towel should be wet, and the second towel should be dry. The same is true for the floor, or use a clean mop to mop evenly)
Note Matters
,
It is generally recommended to use a good quality towel soaked in water to wipe the inside and outside of the furniture. (The concentration of the aqueous solution is that the metal surface is not recommended to be sprayed
. Start ventilating after spraying. If There are a lot of indoor furniture. Formaldehyde evaporates quickly and has a high concentration. It is recommended to spray it several times to increase the degradation rate.
When spraying, generally use a paint spray gun, which has a good atomization effect and will spray more evenly. , improve efficiency.
, Before spraying, clean the surface to be coated, cover the unsuitable spray objects, and keep the spray gun away from the object to be coated.
, The natural drying time of the coating film is about minutes, and it takes hours to fully cure. Do not scrub vigorously before it is completely cured
. When used for sewage treatment, dissolve it with a small amount of pure water first, and then add it to the sewage. It is recommended to take the water behind the secondary sedimentation tank and in front of the biochemical tank, which has better transparency. The treatment effect of sewage is more obvious, and it is more suitable to treat sewage after inorganic sedimentation. The dosage is about one cubic meter of sewage powder.
Packing/bag or/barrel.
Contact Li Mei