Year1
- 111：
- 111
- 11：
- 1111
- 111：
- 11
Manager Wang 1. Inspection of Coke machine accessories
Unpacking and checking whether the machine was damaged during transportation (Figure 1 below). Be careful not to place the machine on its side or upside down.
, Inventory the spare parts and set them aside for later use.
① Installation and maintenance technical manual.
②Carbon dioxide pressure regulator set.
③Install components.
④Water filter.
⑤ Optional syrup pump assembly.
Note that the installation components may be installed in the machine packaging box or in a separate parts box.
The cola machine is positioned
?, reserve the machine location and check the surrounding space.
?, Remove the drain pan and front panel.
? Draw the pipelines (syrup pipe, air pipe and inlet and drainage pipes) on the table
The location and size of the through holes.
?. Make holes on the countertop according to the drawn dimensions. (*)
?, the machine is positioned.
Fill the cola machine sink with water
?. Connect the drain pipe to the drain pan.
?. Water injection hole plug (the black plastic ring facing the front of the machine and located on the left front of the condenser).
? Insert a water pipe or funnel into the water injection hole and turn on the water source until the water flows out from the overflow pipe on the front of the machine.
Note that if the water in the water tank is not filled and the ice plate probe is not completely immersed in the water, the compressor will not start.
Connect the coke machine to the power supply
?, unplug the carbonated motor power plug (the core plug located on the electrical box to prevent the water pump from running when the water source is not connected, and then short-circuit the power supply between the power extension cord socket and the front of the machine Connect the wire plug reliably and insert the power plug.
?. While the machine is on the ice making plate, you can continue with other installation steps.
Note that the compressor and condensing fan will not start until a delay of minutes.
/> Connect the cola machine to the water inlet pipe
Note that if the water source pressure is too high, a pressure reducing valve must be installed and the water pressure is set to.
?. Use a hose to connect the water source switch.
?. Place the hose at the drain. Open the water source and flush the pipe.
?. Use a clean and transparent glass to collect the flushed water. Check whether there are any impurities in the water until there is no impurity in the hose.< br/> ?, Fix the water filter in the appropriate position, install the water filter connector and connect the hose to the water inlet end of the filter.
?, Still use the / hose, one end is connected to the water outlet end of the water filter, One end is connected to the water inlet end of the water pump of the carbonation machine.
?. All pipe joints are tightened with pipe bundle clamps, and the water source is turned on again.
?. Open the pressure relief valve on the carbonation cylinder (yellow lever to drain the system until the water overflows from the pressure relief valve.
?. Check all joints for leaks.
? Press down the beverage valve push rod, operate each beverage valve, and remove the water in the pipeline. air until water comes out of the beverage valve.
WhatsApp
