Supply of rolling shutter machine for greenhouse and solar greenhouse, rolled by motor

Quilt Motor
When selecting a quilt motor for quilts that are mainly used for greenhouse insulation quilts and working light greenhouses, the model specifications should be determined based on the covering material, greenhouse area (length), and the installation position of the reducer. The rolling methods of the quilt motor are mainly divided into middle roll type and side roll type.
Installation and debugging
Pre-welding the movable joints and flanges to the pipes to determine the strength of the crossbar according to the length of the shed (generally, thick-walled high-frequency welded pipes are used for sheds less than 1 meter tall, and thick-walled high-frequency welded pipes are used for sheds over 1 meter tall. In addition to inch pipes for each meter at both ends, high-frequency welded pipes of diameter) and length are used on both sides of the main machine to weld the reel shaft teeth. If a double-tube vertical pole is required, double-tube welding is required.
. Fix the motor on the host machine and install the belt.
Put down the straw curtains on the shed one by one from the middle to both sides, aligning the lower edges, and lay a non-elastic rope under each curtain.
. Dig a pit and bury ground stakes in the center of the shed, away from the shed.
Connect the support rod with a slip knot and a pin to erect and connect the ground pile.
Connect the vertical pole and the main machine, and lay the horizontal poles for preparation.
. Connect the machine rod, that is, the reel, from the middle to both sides.
Fix the rope under the curtain to the shaft teeth.
Connect the reverse switch and power supply.
Test the machine, roll the roller blind machine to the roof of the shed, observe the parallelism of the straw blind, then lower it to the ground, place some old straw blinds and other objects on the slow rolling area and roll it up until it rolls into a straight line.
/ Quilt motor
/ Quilt motor