Year1
- 防爆等级：
- IIC
- 防护等级：
- IP65/IP66
- 工作电压：
- AC220V
Explosion-proof lamps are widely used in hazardous environments such as oil mining, refining, chemical industry, military industry, and offshore oil platforms, tankers and other places. They are suitable for areas with explosive gas environments. , area places, explosion-proof lights are often used in , explosive gas environments.
●The altitude does not exceed
●The operating environment temperature is ~+℃
●The relative humidity of the surrounding air is not greater than (when the temperature is +℃)
●Without damaging metal and insulation properties Places containing gas and steam
●In places without significant shaking and impact vibration
●Pollution level
●Installation category.
Structural characteristics of Hongguan Electric’s explosion-proof lamps
●Product implementation standards/
●This product is an aluminum alloy shell. After high-speed shot blasting, the surface is sprayed with high-voltage electrostatic spraying. It is waterproof and dustproof. , anti-corrosion and other functions. Stainless steel exposed fasteners, transparent parts made of tempered glass that resists high-energy impact, the lamp has a flameproof joint surface structure, but the light source cavity, wiring cavity, and driver cavity are separated, making installation and maintenance easy, and the electrical performance is reliable using high-quality aluminum plate reflectors , improve the efficiency of lamps.
●There are grounding screws inside and outside the lamp casing. Users should be reliably grounded when using this product.
Technical parameters of Hongguan Electrical explosion-proof lamps
Explosion-proof level
Rated voltage
Rated power
Light source type
Protection level
Anti-corrosion level
Dimensions
Installation method: wall-mounted, ceiling-mounted, embedded street light type
Hongguan Electric explosion-proof lamp installation guide
●Before installing the lamp, you should check whether the basic technical data listed on the nameplate are consistent with actual use. condition.
●There is a cable lead-in wire with a diameter of ~~, which is introduced through a rubber sealing ring and connected to the terminal block. Use a compression nut to compress the introduced cable to seal it and prevent it from being pulled out.
●Before use, check whether the wiring is correct and whether the fastening screws (bolts) on the shell are tightened. The cable ground wire should be reliably grounded.
●During maintenance, it is strictly prohibited to open the cover while the power is on, and the rubber sealing gasket must not be bumped or damaged.
●During maintenance, if the sealing ring, sealing gasket, etc. of the introduction device are found to be aging, they should be replaced in time to ensure the protective performance.
Explosion-proof lamp quality assurance
●This product is quality controlled in strict accordance with international quality management system standards to ensure that the product quality is higher than the national standard and fully meets the design requirements. Within the year of purchase, if any failure occurs under normal use of the product ( (non-human fault) will be maintained free of charge by our company.
WhatsApp
