High-quality urea crusher was tested on site and the facts speak for themselves

High-quality urea crusher was tested on site and the facts speak for themselves. The crusher is mainly composed of rollers, roller support, bearings, compression and adjustment devices, and driving devices. No equipment foundation is required, and it can be used after connecting to the power supply. The fineness of the crushing is controlled by the distance between the double rollers. The smaller the distance, the finer the fineness, and the output will be relatively reduced. The uniform crushing effect of adding materials will be better, and the output will be relatively increased. This equipment can be designed according to user requirements. Mobile, the user can move to the corresponding position when in use and move away when not in use, which is very convenient> High-quality urea crusher is tested on-site and the working principle is explained with facts. The material slowly enters a pair of cylindrical grinding rollers that rotate oppositely at different speeds through the diverting roller. between them and be ground into powder. The material is not only subjected to the shear force of the grinding teeth, but also the friction and pressure between the grinding rollers. The grinding effect is good and the energy consumption is low. It is driven by a motor and driven by a triangle belt to the groove wheel to drag the roller. When crushing the material, the material passes through the roller from the feed port and is crushed after being rolled. The crushed finished product is discharged from the bottom of the chassis. When installing the grinding roller of the high-quality urea crusher, pay attention to its tooth arrangement. The tooth shape of the newly drawn grinding roller is arranged from blunt to blunt. This is because the tooth tips of the grinding roller are worn and the output drops significantly. The fast and slow rollers are reversed and turned around so that the tooth shape is arranged as sharp to sharp. When the tooth tip of the grinding roller is severely worn and a large flat surface is formed at the tooth shape, the wire should be redrawn. The high-quality urea crusher was tested on site and used to adjust the gap of the grinding roller to make it uniform. The adjustment method is to compress the pressure springs at both ends to the left and right, so that the pressure of the pressure springs at both ends is consistent. Take a long piece of paper, feed it between the two rollers, make the two rollers contact, and then climb the large triangle pulley. Observe carefully whether the paper is rolled evenly. If there is uneven rolling, the tie rod nuts on both sides must be adjusted to make the pressure on the two tie rods uniform. Factory address: Dahua Machinery Factory, Fenghuangling Street, Hedong District, Linyi City, Shandong Province Telephone: Mobile phone