wall threader, hole punch

Fiberglass perforator technology can be customized in any meter, with a range of applicability, a minimum bending radius of 100, and a line density of traction breaking tension of 100,000 square meters. It uses engineering plastics imported from Taiwan as the main raw material.
Uses of fiberglass perforators
Perforators are mainly used to pull cables in pipelines to clear the pipelines. They can drive various steel wire cables through narrow channels easily, so many construction units call them pipe perforators. Fiberglass perforators are essential communication tools for telecommunications, power and communications units.
Correct operation method of FRP puncher
Be sure to protect the pulling head from being broken. When using it, first align the traction head with the movable pulley on the small frame, pass it through the pulley, and then perform threading, pulling, and dredging the pipe. If you need to pull all the punches out of the frame, you should pay special attention to the fact that the last end is stuck in the ring on the small frame. This ring is used to fix the pulling head when coiling the punches. Therefore, you must be careful to break the traction head when pulling it out at the end, and when retracting the punch, you must first get the traction head stuck in the middle of the ring.
The fiberglass perforator is a hard and brittle material, so you should keep the minimum bending diameter not less than 1 centimeter during use. In pipelines or other construction environments, if the angle of the pipeline is at right angles or less than 10 degrees, , special attention should be paid to protecting the traction head from being broken, and certain measures should be taken to prevent the threader from being damaged when pulling out the shaft.
The temperature range that the fiberglass piercer can withstand is between 1 and 2 degrees Celsius. Any improper behavior should be avoided during construction, such as contact with overly cold or overheated objects or environments. The product should be placed in a cool place after use to avoid Prolonged exposure to sunlight and rain.
The maximum straight-line traction force of the FRP punch is 0. Do not use high-power machinery for traction in a perpendicular environment, otherwise it may break. Never let vehicles or other heavy objects roll over it, otherwise its service life will be greatly shortened.
When using a threader in large-scale cable construction, you cannot use a perforator to pull the cable directly. You should use a metal pulling head to first pull a steel wire rope in the pipe, and then use the steel wire rope to pull the cable. In this way, the life of the perforator will be greatly improved. It is recommended to use various pay-off pulleys to improve work efficiency and protect the punch