XCD type fixed car stop price, fixed car stop low price

Type fixed car stop
Price
,
Fixed car stop
Low price
Fixed car stop
,
Fixed car stop
Price
,
Fixed car stop
Quality
,
Fixed car stop
Usage
,
Fixed car stop
Manufacturer
,
Fixed car stop
Installation method
,
Fixed car stop
Model
Walk by, pass by,
don’t
miss it!
Look at the East, look at the West, if you want to buy a car stopper, you should choose Shandong Zhongmei Di, Shandong Zhongmei
Professional production
Car stopper
,
Hydraulic car stopper, Fixed car stops, etc., absolutely guaranteed quality and sold at low prices.
Fixed vehicle stopper
Purpose
It is a product designed according to the actual situation of the user and to meet the specific requirements of the user. It has short occupied lines, simple structure, low cost and easy maintenance. It can be used in situations where the vehicle group is small and the impact speed is not high.
Installation method of type fixed stopper
①Place the left and right arms on the basic rail and connect them to the support with arm pins.
② Lift the support arm and place the spring seat, leaf spring and bearing seat in sequence on the basic rail below the shoe type fastener.
③Clamp the shoe block with the brake rail, and also clamp the rail head of the basic rail, and then use three bolts to attach the brake rail. Note that the two outer bolts must pass through the support frame, and the bearing seat should be located in the center of the pressure hole.
④ Use the front and rear cross beams and the upper and lower inclined beams to connect the four lower legs of the two arms. The overlapping form is shown in the figure. The middle and four corners of the two inclined beams are tied with pins. After completing the above initial installation, tighten all bolts.
⑤Use a pressurizer to pressurize each spring plate. Insert the shaped pressurizing fastener into the spaces on both sides of the bearing. Align the head of the pressurizing screw rod installed on the center nut of the pressurizer with the pressurizing block and hang it on both sides. The side pressurized rail bottom plate is hooked on the basic rail bottom plate and tightened with nuts. Use an iron rod about long to twist the pressurizing screw and drive the wedge iron between the bearing seat and the leaf spring so that the gap between the leaf spring and the spring seat is 1 meter.
⑥Install the signboard on the support.
⑦After each installation, position marks should be painted on the rail waist to facilitate daily inspection to see if the train stopper has been damaged.
Fixed car stop
,
Fixed car stop
Price
,
Fixed car stop
Quality
,< br/> Fixed vehicle stopper
Purpose
Contact person
Manager Wang
Mobile phone number



Contact
Telephone



Fax number

Number

Company name China Coal Industry and Mining Materials Co., Ltd.