Professional QYW-25-45 pneumatic sewage submersible pump manufacturer

1. Product introduction A new type pneumatic sewage submersible pump is designed based on the new type air pump. The pump has beautiful appearance, small size, light weight, and large flow rate. The overflow part adopts a downdraft structure. The impeller is semi-open and made of modified materials. It can pass particles and has strong sewage discharge capacity. It will not be caused by small solid particles or fibers. It will not be blocked due to inhalation, nor will it be damaged prematurely due to the inhalation of abrasive media.
The overall structure of the pump is simple, easy to move during assembly, disassembly, and maintenance. It is absolutely safe and reliable to use on working surfaces containing gas and coal dust. It is equipped with an advanced and novel device at the exhaust port, which greatly reduces the actual measured noise. , greatly improving the working conditions for underground use.
2. Model representation
Vane air motor
Sewage submersible pump
Rated flow
Cubic meters
/
Hours
Rated head
meters
3. Main technical parameters
Lift meters
Flow rate cubic meters
/
Hours
Rotational speed rpm
Using wind pressure in MPa
Air consumption in cubic meters
/
Minutes
Fuel consumption in milliliters/hour
Total weight in kilograms
Overall dimensions (length Width and height) mm
(
Excluding joints and *)
The structure and working principle, use and maintenance of the type pneumatic sewage submersible pump can be referred to the type pneumatic submersible pump.
4. Structure and working principle
The pump consists of five parts: air motor, water pump, lubricator, pipe joint and *.
The motor part consists of a rotor, blades, cylinder, casing, upper and lower cylinder heads, top cover, etc. There are five evenly distributed radial grooves on the rotor. There are blades in the grooves. There is a blowing eye on each of the upper and lower cylinder heads. When the air pump is started, high-pressure air blows away the blades in the groove from the blowing eye. At the same time, a large amount of High-pressure air enters the cylinder from the main air duct, pushing the blades and driving the rotor to rotate and perform work. There is a sealed cavity under the casing, and a sealing ring is used in the cavity to separate air and water. The sealing ring adopts spring sealing, and uses the pressure of air and water to expand the sealing ring to enhance the sealing effect.
The body part consists of pump body, impeller, pump cover, pump base, etc. The impeller is installed on the rotor shaft, tighten the impeller nut, install the pump body and pump base, and put it into the water. The rotor drives the impeller to rotate. Under the action of centrifugal force, the water flow is pressed into the vortex of the pump body and discharged along the outlet pipe.
The mist part consists of a lubricator shell, a lubricator core, an oil regulating valve, etc. The oil mist device is installed on the top cover, and the shell is filled with lubricating oil.
The joint part consists of two parts: quick combination joint and quick change pipe joint. The quick combination joint is installed at the water outlet, while the quick-change pipe joint is installed at the air inlet.
Part of the * is made of steel plate stamping and welding, and is installed at the exhaust port.
Mainly engaged in submersible pumps
Electric pumps
Sewage pumps
Sand pumps
Grouting pumps
Air pumps
Pneumatic pumps
Self-priming pump
Turbo submersible pump
Contact Ms. Wu
Mobile phone
Telephone
Your satisfaction is what we pursue, and we have been working hard.
Guolong welcomes your call