Supply imprinted flooring

(Welcome to contact Manager Weng
Requirements for base concrete construction in imprinted floor construction
The strength of the base concrete should be as small as possible in its water-cement ratio and the tamping should not contain early strength agents.
Concrete The largest crushed aggregate particle size is appropriate and the minimum thickness of the base concrete must be.
The slump of concrete should be controlled at slump of commercial concrete should be controlled at
The gravel plain soil foundation must be rolled Machine compaction or tamping.
The following concrete is vibrated using a flat vibrator. The above concrete is vibrated using a plug-in vibrator.
Use a heavier steel long roller (the steel roller should be wider than Formwork (meters or more) is rolled repeatedly to make the floor level. When rolling the floor, all foreign objects on the steel rollers should be removed. Lift out the concrete mud to ensure that there is no sand and gravel on the surface in areas where steel rollers cannot be used. A sample plate should be used to scrape out the floor level.
Bleeding treatment should be carried out after the concrete floor level is completed.
It is required that the gradation of the bottom concrete is or the upper layer is or the total thickness of the mortar fine stone concrete is
Imprinted floor construction steps
Concrete surface roughening treatment. Add cement slurry before the initial setting of the concrete surface. Use a manual iron plate to evenly smooth the concrete surface with water mortar and roughen the surface.
Spreading hardening materials will be specified. The amount of hardener stamped flooring is evenly spread on the surface of the concrete in the initial setting stage. After the hardened material absorbs water and is moistened, it is leveled and polished with a manual iron plate to complete the first operation. The second operation is performed after the initial setting of the hardened material reaches a certain stage. Material spreading, finishing and leveling operations.
Leveling, finishing and leveling operations should be carried out at least three times according to the hardening conditions of the concrete, and the finishing operations should be staggered.
Spreading and demoulding When the surface of the hardened material is dry and has no obvious moisture, evenly spread a layer of release powder that matches the hardened material at a certain stage of initial setting.
Use the mold to press the pattern and keep the mold fixed and flat. The pressed pattern must be formed in one go and cannot be pressed again. .
Achieve various design styles, textures and colors, and also can interactively design in multiple colors.
Imprinted ground imprinted ground