Liuzhou Siemens washing machine repair phone number [3.15 recognized after-sales center]

Liuzhou Siemens after-sales maintenance telephone number Liuzhou Siemens repair manufacturer service telephone hourly appointment repair center Siemens
Washing machine is noisy
Washing machine has been used for a long time due to mechanical wear and lack of lubricating oil, aging of parts, spring fatigue deformation and other reasons. Abnormal vibration and noise. If not repaired in time, the parts of the washing machine will wear out or even be damaged. In fact, vibration and noise can be eliminated or reduced through appropriate adjustments and simple repairs.
The body of the washing machine makes a banging sound. This fault is mostly caused by a collision between the washing tub and the outer casing or the fact that the floor where the washing machine is placed is uneven and the feet do not maintain good contact with the ground.
At this time, it is necessary to adjust the center of gravity of the washing machine and place it stably or to place appropriate blocks on the four foot pads.
When washing, the impeller rotates and makes a grinding sound. During maintenance, water can be put in without clothes for inspection.
At this time, if there is still a rattling sound when the impeller is rotating, it means that it is caused by friction between the impeller and the bottom of the washing tub when it is rotating. If more clothes are put in, the noise will be louder.
The cause of the fault may be that the impeller screws are loose. You can disassemble the impeller and add a washer of appropriate thickness at the bottom of the shaft to increase the gap between the impeller and the bottom of the barrel to eliminate collision or friction between the two.
If the outer ring of the pulsator rubs against the washing bucket, the pulsator should be removed, re-trimmed, and then reinstalled.
The rotating belt makes a crackling sound when the motor rotates. The fault is caused by a loose drive belt.
During maintenance, you can loosen the fastening screws of the motor base, rotate the motor away from the pulsator shaft to tighten the transmission belt, and then tighten the fastening screws of the motor base.