Factory direct sales shot blasting machine accessories impeller shot blasting machine

The double discs in the shot blasting device are riveted together to form the impeller body. Eight blades are installed on the impeller body. The impeller body and the shot splitting wheel located in the center of the shot blasting wheel are mounted on the main shaft driven by the electric motor. The cover is lined with a protective plate, and the cover is equipped with a directional sleeve and a shot tube. During operation, the projectiles flow into the shot blasting device from the shot inlet tube. The shot splitting wheel that rotates synchronously with the blades causes the projectiles to gain initial velocity. The projectile flies out through the window of the directional sleeve and is thrown onto the high-speed rotating blades outside the directional sleeve. After being further accelerated by the blades, the projectile is projected onto the surface of the workpiece to be cleaned. Because the shot splitting wheel and the blade rotate synchronously, the vibration-free transmission of the projectile to the blade is ensured, thereby reducing the wear on the blade. . Sealing performance of the shot blaster
. The transition area between the inlet and outlet is equipped with multi-layer sealing curtains to prevent abrasives from escaping from the inlet and outlet when the workpiece enters.
b. The top opening of the shot blasting chamber is equipped with a manganese steel labyrinth baffle, a double-layer rubber seal and a sealing brush to prevent abrasives from flying out of the shot blasting chamber from the top.
.High-performance shot blasting machine
The shot blasting machine has a high-quality welded shell lined with wear-resistant protective plates, which can be used throughout the life of the shot blasting machine without the need for replacement or repair welding. The shell of the shot blaster of domestic shot blasting machines is easily damaged and often requires repair welding.
The double-disc shot blasting machine has a blade made of special hard manganese steel. The impeller aperture is directly connected to the motor shaft without any connector in the middle. Even if the domestic shot blasting machine has a pull-out design, the impeller and motor still need to be connected through multiple connectors, which can easily cause abrasive leakage, poor sealing, and high wear.
The special blade arrangement design of the shot blaster has a low scattering rate and the abrasives are directed to the target location. This not only improves the throwing efficiency, but also reduces the damage to the shot blasting machine. However, the domestic shot blasting machine has a high scattering rate, and the abrasives will scatter in an undirected manner.
The shot blaster guide sleeve and shot splitting wheel made of special hard manganese steel can accelerate the shot blasting in advance, thereby improving the projectile effect and increasing the projectile angle.