Gansu Tianshui rubber bearing round factory direct sales 15533808610

The contact number of the contact person is Manager Zhang:
Rubber bearing replacement: 70% depends on quality and 30% depends on maintenance. Rubber bearings may experience some unsatisfactory conditions during the trial period. The passing rate of plate rubber bearings manufactured by Hengshui Guangtong Rubber Products Co., Ltd. is . After purchasing and constructing plate rubber bearings, the plate rubber bearings should be maintained and inspected regularly. Once problems are found, the rubber bearings should be repaired or replaced in time.
, Plate rubber bearings and PTFE skateboard rubber bearings should check the following contents
: Whether the rubber bearing has slippage and hollowing out
Whether the shear displacement of the rubber bearing is too large (The shear angle should not be greater than 3)
: Whether the rubber bearing has excessive compression deformation (the maximum compression deformation shall not exceed ., which is the total thickness of the rubber layer of the bearing)
Rubber bearing rubber Check whether there are aging signs such as cracking or hardening in the protective layer, and record the gap location, crack width and length
Whether the protrusion of the rubber plate between the stiffening steel plates of each layer of the rubber bearing is even and normal
For PTFE For the skateboard rubber support, you should check whether the layer of polytetrafluoroethylene skateboard on the support is complete and whether there is any peeling phenomenon, whether the support has slipped out of the stainless steel plate on the top of the support, whether silicone grease is applied and filled with PTFE Oil reservoir for skateboard rubber bearings.
All parts of the rubber bearing should be kept complete and clean. Clean up the garbage and debris around the bearing in time, and remove snow and ice in winter to ensure the normal operation of the rubber bearing. At the same time, sewage should be drained frequently, water accumulation on piers and platform caps should be eliminated, rubber bearings should be prevented from contacting grease, and residual engine oil on the bottom of beams and piers and platform caps should be cleaned. Prevent rubber from losing its effect due to aging and deterioration.
If the pressure on the beam fulcrum is uneven, and the rubber bearing is hollow or has excessive compression deformation, it should be adjusted.
When the plate rubber bearing has excessive shear deformation, aging, cracking, etc., it should be replaced in time.
For the rubber support of the PTFE slide plate, if sediment is found between the contact surface of the PTFE slide plate and the stainless steel plate or the silicone grease dries up, it must be removed in time and new silicone grease should be injected. Hengshui Xurui Engineering Rubber Co., Ltd. specializes in the production of rubber bearings, isolation rubber bearings, rubber pads, basin-type rubber bearings and other construction rubber bearings. The price of rubber bearings is high quality and low price. Welcome all buyers to purchase! Products have been sold to: Henan Luohe, Wenchang, Gansu Qingyang, Guangdong Jieyang, Shenzhen, Guangxi Laibin, Henan Wenchang, Fujian Nanping, Anqing, Bengbu, Chizhou, Tongling, Fuzhou, Longyan, Putian, Quanzhou, Tianshui, Lanzhou, Qingyang , Guangzhou, Foshan, Shaoguan, Shenzhen, Yunfu, Zhongshan, Baibai, Beihai, Tongren. Manager Zhang