Engineering plastic drag chain supplier

The structure of engineering plastic drag chain

(1) The drag chain looks like a tank chain and is composed of numerous unit links, which can rotate freely between links.

(2) The inner height, outer height and pitch of drag chains of the same series are the same, but the inner width and bending radius R of the drag chain can be selected differently.

(3) The unit chain link is composed of left and right chain plates and upper and lower cover plates. Each link of the drag chain can be opened, which is easy to assemble and disassemble. No threading is required. After opening the cover plate, cables, oil pipes, air pipes, water pipes, etc. can be put into the drag chain .

(4) Separators can also be provided to separate the space within the chain as needed.

Applications of engineering plastic drag chains

1. Suitable for use in reciprocating motion situations, and can pull and protect built-in cables, oil pipes, air pipes, water pipes, etc.

2. Each section of the drag chain can be opened for easy installation and maintenance. It has low noise during exercise, is wear-resistant, and can move at high speeds.

3. Drag chains have been widely used in CNC machine tools, electronic equipment, stone machinery, glass machinery, door and window machinery, injection molding machines, manipulators, lifting and transportation equipment, automated warehouses, etc.

Basic parameters

(1) Material: Reinforced nylon, with high pressure and tensile load, good toughness, high elasticity and wear resistance, flame retardant, stable performance at high and low temperatures and can be used outdoors. The amount of nylon content determines the strength and wear resistance of the drag chain as well as the noise during operation. Nylon content ranges from 5% to 17%, but cannot exceed 19%. Generally the content is around 30%.

(2) Resistance: oil-resistant, salt-resistant, and has certain acid and alkali resistance.

(3) Operating speed and maximum speed: the maximum speed can reach 5 meters/second, and the maximum acceleration can reach 5 meters/second (the specific speed and acceleration depend on the operating conditions).

(4) Operation life: Under normal overhead use, it can reach 5 million reciprocating movements (the specific life span depends on the operation conditions).

Selection principles

Inner height: Select the thickest one among the built-in cables, oil pipes, air pipes, water pipes, etc. as the reference height, plus at least 10% of the height space as the inner height of the drag chain. If overlapped, use the actual height after overlap as the reference height.

Inner width: Select some thicker cables, oil pipes, air pipes, water pipes, etc. The sum of their outer diameters is used as a reference for the inner width of the drag chain, and leave at least 10% of the width space.

Bending radius: Select the largest bending radius among the built-in cables, oil pipes, air pipes, water pipes, etc. as the reference value, and leave more than 10% of the space. The placement principle of the built-in cables, oil pipes, water pipes, and air pipes in the drag chain.

There should be 15% remaining space so that built-in cables, oil pipes, etc. can move freely without exerting any pulling force on the drag chain in the radial direction.

Conductors with large diameter differences should be laid separately, their weight evenly distributed, and separated by separators if necessary.

When operating at high speed or high frequency, try to keep the wires separated from each other horizontally and do not overlap each other. It is recommended to use separators when there are many cables, air pipes, oil pipes, etc.

installation method 

Use an appropriate flat-head screwdriver to vertically insert into the opening holes at both ends of the cover, open the cover, put the cables, oil pipes, etc. into the drag chain according to the placement principles we provide, and then close the cover. In addition, the fixed and movable ends of the wires All should be fixed by removing the tension device. When using for long-distance sliding, it is recommended to use guide grooves. Please consult the company's professionals for the use and installation of guide troughs.