The leakage problem of steel mesh skeleton pipe must be dealt with as soon as possible

Pipe leakage is very common in real life. No matter where it is, no matter what material or type it is, if such a situation occurs, it is detrimental to us. Steel mesh skeleton pipes can also happen due to external reasons. In such a situation, it is crucial to take remedial measures in a timely manner.
When the geological conditions change and the steel mesh skeleton pipe is forcibly damaged by external forces, pipe wall leakage, pipe rupture, and joint leakage may occur. The repair method should be determined based on the degree, location, and cause of the damage to the pipe.
Replacement of damaged pipes and pipe fittings should be carried out in accordance with construction and laying requirements.
For pipeline damage caused by external reasons such as pipeline foundation settlement, temperature changes, external load changes, etc., corresponding measures should be taken to eliminate various external factors after the pipeline is repaired.
Pipeline Repair Methods
When the joints of electrofusion and hot-melt connections of pipes and pipe fittings leak, the pipes should be cut off and the pipes, steel mesh skeleton pipes and fittings should be re-connected by electrofusion and hot-melt connection according to the construction requirements.
When the damage range of the pipes connected by electrofusion or hot melt is very small, use the electrofusion sleeve or modified saddle-shaped electrofusion pipe fitting repair method to cut off the damaged part of the pipe, and then use the electrofusion sleeve or modified saddle. Connect the shaped electrofusion pipe fittings.
When the damage range of the pipes connected by electrofusion or hot melt is large, the damaged pipe section must be cut off and replaced with a new pipe. The interface can be connected by electrofusion, hot melt or flange, but the last welding port must be Use electrofusion sleeve connection or flange connection.
When the steel wire mesh skeleton pipe is flexibly connected by a socket-type rubber ring, the damaged pipe section can be cut off, replaced with a new pipe, and then connected with a double pipe hoop or an movable sleeve (emergency joint repair device) .
When a pipe with a nominal outer diameter less than or equal to 3mm is damaged, the damaged pipe section can be cut off, replaced with a new pipe, and the steel mesh skeleton pipe is then connected with a repair device.
The problem of water leakage should not be underestimated. If we do not pay attention to some small details, then we will lose more water resources, and over time our steel mesh skeleton pipes may suffer secondary damage. In addition In addition, we must select the construction site before construction and take preventive measures for possible problems.