Year1
- 规格：
- 7米
- 材质：
- 不锈钢/铝合金
- 型号：
- MW098
It is convenient, easy to operate, safe and reliable, and can be set up at any time for mobile defense without affecting the smooth flow of normal roads. It is necessary to set up a card to intercept suspect vehicles. Indispensable advanced equipment.
The main body of the roadblock is made of high-strength alloy aluminum, the spikes are made of alloy steel, the outer casing is made of B engineering plastics, and the power supply is a new lithium-ion battery, which ensures the roadblock's service life and superior electrical performance.
2. Main technical parameters:
, effective length of roadblock: (-adjustable), effective length of deflated steel nails:
effective spacing of deflated steel nails:, deployment (recycling) speed: /(Grade pavement)
, Loading weight: ≮, Remote control distance:
, Working voltage: - (LCD display with voltage), Power supply capacity: / (Lithium battery, with over-discharge protection)
/> , Continuous working time: Continuous retracting and retracting operations, standby time hours
, Charging power supply: Charging time: -, Car charger:, Charging time:
, Machine weight:, Box size:
3. Working environment:
, Ambient temperature: ℃, can be used normally in rainy days (not immersed in water)
4. Instructions for use:
, Equipment box wheels should be placed downwards Go to the road and open the locks on both sides of the traction device in the unfolding direction. Turn on the power switch of the traction device (the red button lights up to indicate standby mode).
Pull out the antenna of the remote control and press the forward button (up button). The nail strip will expand to the required length and release the button to stop.
When retracting, press the back button (B down button) to close the nail belt and release the button to stop.
(Note: The remote control is equipped with a delay function. Master the advance amount during operation, otherwise it will cause damage due to strong inertia impact on the box)
When collecting the box, align the traction device with the interface of the nail tape box Match, then put the box upright and press the locks on both sides.
Please choose a flat road surface when laying out.
If the remote control operation is not possible due to electromechanical failure, you can hold the traction device to pull out the nail strip and complete the layout manually.
5. Precautions: (Please read carefully before use)
Since the turning nails are sharp, be careful to avoid injury during operation and maintenance.
When laying out the spike strips, special personnel must be on duty near them to avoid accidental injury to pedestrians and vehicles.
During the deployment and interception, it is strictly prohibited for any person to appear within 1 meter of the inertia direction of the intercepted vehicle and the spike belt to avoid injuries caused by the vehicle losing control after a tire puncture
and other reasons.
When the equipment is idle for a long time, it needs to be charged once every day (the LCD voltmeter is lower than .), and the power switch must be turned off in time after use.
It is strictly prohibited to drop or hit the equipment box with malicious intent.
This product is an electromechanical product. Please pay attention to waterproofing, moisture-proof, and exposure-proof during use and storage.
When reinstalling nails, be sure to place the rubber ring on the top of the nail shaft (nail base) first, otherwise the nails will fall off easily.
6. Judgment and maintenance of general faults
If a remote control fault occurs, please follow the following steps:
Check whether the power supply of the remote control is normal (whether the battery of the remote control needs to be replaced).
Check whether the power supply of the equipment box is normal (the lithium battery can be retracted and retracted continuously for more than
hours or can be kept on standby for more than
hours after a normal charge. If the equipment's working efficiency drops significantly, consider replacing the battery with a new one).
Check whether the circuit board is normal (whether the circuit board indicator light is on when the power is turned on).
If the nail strip (aluminum strip) cannot be retracted and retracted normally due to deformation, please manually adjust the deformed aluminum strip to straighten it to return to normal.
The product is an electromechanical product and non-professionals are strictly prohibited from dismantling it by themselves.
WhatsApp
