Self-cleaning epoxy floor dust-free grinder electric floor grinder old epoxy floor renovation machine

Product description:
The floor grinder involves the field of ground leveling construction, especially one suitable for concrete epoxy resin wear-resistant floors, flatness restoration of hardened floors, surface roughening, old epoxy renovation, cement Ground grinding, removal of old epoxy, paint treatment, rust removal of steel plates, polishing of epoxy intermediate putty, removal of old floors such as thin-coated epoxy, glue, and paint, fine sanding and leveling of epoxy mortar layers, and polishing and absorbing The dust-in-one operation is convenient and quick.
Product features:
The floor grinder performs simultaneous grinding and dust collection to achieve dust-free construction
. The machine is equipped with diamond tools of different thicknesses, which can grind all types of floors. Such as hardened wear-resistant, terrazzo, emery floors, various types of concrete base surfaces, grinding, trimming and roughening treatment. In addition, thin layers of paint and epoxy can be ground and removed
The chassis can be freely replaced, and consumables can be freely configured (diamond Grinding head, remove the old epoxy grinding head, cutting knife, grinding wheel, sand paper, etc.)
, the fine grinding tool can be used for fine grinding of the floor surface, and can also be used for leveling the middle layer of the epoxy floor.
The low center of gravity design of the machine greatly improves the operating comfort and stability during high-load construction
It is equipped with a reverse steering switch. If you find that the motor is reversed, just toggle the switch. Change the rotation direction of the motor
It is equipped with a leakage protector, which greatly improves the safety of the operator
The machine body is small and flexible to operate, so it is not limited by the size of the construction site. The body and the wall during construction There are no dead corners
, imported motor, strong suction, extremely low failure rate and continuous dust-free construction for hours
. The main motor and vacuum motor are controlled by separate switches for convenient use.
Instructions for use:
, take the machine out of the packaging box, lay it flat on the ground
, remove the motor cover and check the tightness of the belt. If the belt is loose, press the handle hard to tilt the chassis. Loosen the four fixing screws of the chassis, then tighten the lower push bolt with your hand until the specified tightness is reached, and then install the shell.
After the chassis is tilted, the triangular disc is exposed. Install the grinding head on the triangular disc and fix it, and then adjust the outer skirt to the appropriate position.
, lay the machine flat and ensure that the three grinding heads on the triangular disc and the rear wheel are on the same plane.
, plug in the power, rotate the switch to start the machine, if the dust comes out, turn the switch to the middle stop state, then turn it to the opposite direction, then it can operate normally.
After the machine is started, the appropriate speed can be selected to advance uniformly according to the ground strength and processing effect.
, the machine can be stopped after running for about 10 minutes, and then reversed to remove the dust on the filter to achieve better vacuuming effect. After running for 10 minutes, stop the machine, open the lower compartment of the vacuum cleaner, and clean the inside of the vacuum cleaner. Dust clean.
If there is any abnormality during operation, please stop the machine immediately and inspect it before re-using it.
Jining Dingcheng Industrial and Mining Equipment Co., Ltd.
Contact person: Zhang Wenfeng
Mobile phone
WeChat:
Landline
Fax:
: