Construction of imported Cerron artificial turf football field

型号：

mp50

规格：

50mm

密度：

10500

Detailed description of the construction of imported Serron artificial turf football fields: Domestic artificial turf football fields first emerged around the year 2007. After nearly two decades of development, they have been widely used in large, middle and primary schools, kindergartens, enterprises and institutions, as well as professional competition and training grounds. use.
The structure of grass fiber has developed from the initial network structure to extruded monofilament and later derived products such as reinforced monofilament and molded monofilament. The bionic performance is getting closer and closer to the softness and wear resistance of natural lawn. , tensile strength
are further increased.
The lawn structure has also developed from a single straight wire to a curved structure, from a filled type to a filling-free lawn.
No matter how the product is developed and advanced, the steps to build a football field are basically the same. Let’s further explain the steps to build a high-end artificial turf football field:
1: Basic part
.Cement foundation
The strength of the cement foundation reaches the strength of building concrete. It is recommended that the thickness should not be less than cm thick. When casting cement concrete, do not throw cement ash on the surface of the cement concrete. The finish should be vibrated on the original slurry and
watering, curing or covering should be done. maintenance. Turtle-shaped drainage slopes from three thousandths to five thousandths.
.Asphalt base asphalt concrete surface layer structure: medium-grained asphalt and fine-grained asphalt. The seams should be tight and smooth, and straight-cut heat welding should be used. The longitudinal seams of the upper and lower layers should be staggered. The longitudinal seams of the upper surface layers should be straight. The transverse seams of two adjacent panels and the upper and lower layers should be staggered by more than one degree. The construction of transverse joints should first be carried out with a two-wheel or three-wheel steel drum roller for transverse rolling.
.Panax notoginseng soil
Soil materials: Use clay soil dug out on site and silt soil with a plasticity index greater than 100%, which must not contain organic impurities or cultivated soil. The soil should be sieved and its particles should not be greater than 1%. The moisture content of the soil should be controlled according to laboratory tests.
Lime part: Fresh lump ash should be digested and sieved before use. The particles should not be larger than the lime and should not contain unslaked quicklime and other impurities and should not contain too much moisture.
2: Cushion part
A high-end football field generally needs a buffer layer before paving artificial turf to increase the elasticity of the entire field and protect athletes from injury. Foam materials or rubber layers are generally used. Generally varies from -
Usually rolled composite materials.
Three: Selection and installation of artificial turf:
Artificial turf generally chooses extruded monofilament or reinforced monofilament. The decitex value is generally above D. If conditions permit, you can choose artificial turf woven with imported grass fibers.
Seam tapes must be used for the installation joints and the width should not be less than 1 cm. Special glue for artificial turf should be used to bond such a site so that it is not easy to open seams. Secondly, the amount of filler is the top priority of the entire lawn
It cannot be too much or too little. The filling amount of quartz sand in general artificial turf is about 100%, and the number of rubber particles per square meter is about 10%.
The entire site is a systematic project and should be installed by professional construction personnel! Welcome to call Qingdao Boxiangyuan Artificial Turf Co., Ltd. We will enthusiastically answer your various construction problems!