Walrus Pipe Rubber Water Blockage More Surprises G

Supply of rubber balls for pressure testing of building pipelines and rubber water plugs for pipelines
Building sewer pipes for pressure testing and detection are made of high-quality rubber materials. When used, the rubber water plugs for the pipes are put into the pipe and can be closed immediately after inflating. The rubber water plug of the pipe can withstand more than 1 atmospheric pressure and can be used repeatedly. The pipeline rubber water plugging air bag used for pipeline testing and pressure sealing is made of composite materials newly developed by our company. It has strong pressure resistance and blocking effect. It has been proven by many construction units across the country that the quality, reliability and stable performance of this product are the best for pipeline sealing. Ideal tool for construction.
How to use the pipe rubber water plug:
Preparation: First, combine the accessories of the pipe rubber water plug inflatable device to check for tool leakage. Place the rubber water plug on the pipe in a bucket filled with water and press and hold the air pump to inflate the rubber water plug on the pipe. Check whether the rubber water plug on the pipe is leaking.
Open the inspection port of the riser and slowly feed the pipe rubber water plug upwards from the opening. Then inflate the pipe rubber water plug so that the pipe rubber water plug is in close contact with the inner wall of the pipe and the water will not leak (experience is Taking the model as an example, when inflating, shake the air bag by hand until the air bag and the tube wall are just combined, and then slowly inflate it with a pump. At this time, the air bag can withstand the natural water pressure of the layer.) The operator inflates the lower layer and fills the upper layer with water. Note that pipe rubber water plugs should not be placed at the joints of riser pipe fittings. Reasons: There are seams on the inner wall of this place that affect the tightness of the water plugging. In order to prevent the rubber water blockage in the pipe from expanding to one side, the air pressure cannot be pumped up. If the rubber water blockage in the pipe continues to be inflated, the rubber water blockage in the pipe will be broken. For cast iron drainage pipes, the sand must be cleaned and the inner wall should be smooth. No burrs are allowed, otherwise it will affect the water sealing and even puncture the capsule. Open the inspection port of the riser and slowly feed the pipe rubber water plug upwards from the opening. Then inflate the pipe rubber water plug so that the pipe rubber water plug is in close contact with the inner wall of the pipe. The water will not leak. Pipe rubber water plugs of various specifications can be used. Must be used in the corresponding pipeline and cannot replace large with small.
. Pour water into the water filling port on the floor (you can also use the inspection port) to the height of the floor. Then check the watering pipes and pipe fitting interfaces one by one. If any leakage is found, mark it and drain it. Repair it if the rubber ring is flexible. The interface can be repaired with water tight bolts at the leaking interface. If there is no leakage point in the inspection of the irrigation pipeline, the water level can be stabilized and the irrigation time lasts for 10 minutes and the irrigation liquid level does not drop for 10 minutes, which is considered qualified.
Deflate the rubber water plug of the pipe and then slowly pull out the rubber water plug of the pipe. Be careful not to damage the rubber water plug of the pipe.
Our pipe rubber water blocking products have been sold in the following cities: Beijing, Shanghai, Chongqing, Tianjin, Guangdong, Hebei, Shanxi, Inner Mongolia, Liaoning, Jilin, Heilongjiang, Jiangsu, Zhejiang, Anhui, Fujian, Jiangxi, Shandong, Henan, Hubei, Hunan, Guangxi, Hainan, Sichuan, Guizhou, Yunnan, Tibet, Shaanxi, Gansu, Qinghai, Ningxia, Xinjiang
Screenshot