Year1
- 厂家：
- 衡水德祥
- 规格：
- 400*10
- 型号：
- 651
Shouguang externally attached rubber waterstop #Back-attached waterstop Dexiang patented technology Shouguang externally attached rubber waterstop #Back-attached waterstop Dexiang patented technology Shouguang externally attached rubber waterstop #Back-attached waterstop Dexiang patented technology Shouguang externally attached rubber waterstop #Back-attached waterstop Dexiang patented technology Shouguang externally attached rubber waterstop #Back-attached waterstop Dexiang patented technology < br/> Externally attached waterstop joint method: Externally attached rubber waterstop adopts cold bonding method. . Environmental requirements: The construction site should be clean. . Use a clamp to cut two opposite angle bevels from the two waterstops. Use a sanding machine to sand the back of the waterstop and the rubber plate of the same material (the length of the rubber plate should not be less than the width and be equal to the width of the waterstop). rough surface). Also prepare a sealing film with thickness, width and length longer than the section of the water-stop tape and polish the adhesive surface. . Use high-grade gasoline to clean the bonding surfaces of the waterstop and rubber sheets before connection. Brush with neoprene adhesive ~ The drying time each time is approximately (the adhesive should be slightly sticky when touched by hand). First stick one side of the waterstop on the rubber board and then align the other side of the waterstop with the waterstop stuck on the rubber board until the corner is glued on the rubber board. Then use a wooden block to hit the waterstop groove with a wooden hammer to make it stick firmly. Roll the protruding parts with your hands to make them stick tightly. Use sealant putty to fill loose joints, and finally apply neoprene adhesive to the joint between the film and the waterstop to seal the joint. Externally attached waterstop quality assurance. Materials entering the site must have a product certificate (or material inspection report), a copy of the business license with an official seal, and a material re-inspection report. . When transporting materials, avoid direct sunlight and avoid contact with heat sources, oils and harmful solvents. Do not stress the finished product. . Construction personnel should strictly inspect material specifications and appearance for defects. . Construction operators with professional waterproofing qualifications are employed with certificates and are operated by experienced construction personnel. . When positioning the waterstop, be sure to keep it flat and not allow it to turn over. If it is kinked, it should be adjusted in time. . The waterstop must be pasted accurately and securely. The connection of two parallel waterstops should be staggered. . The concrete poured on the waterstop must be vibrated and compacted so that it can bond well with the concrete. . Before pouring concrete, remove all debris in the waterstop tank and rinse it with clean water to ensure that the tank is clean. Externally attached waterstop, back-attached waterstop, back-attached rubber waterstop, externally attached rubber waterstop
WhatsApp
