Year1
- 袋装：
- 50kg
Beijing polymer clay manufacturer price contact number: Contact person: Liu Xiaohong
Type polymer dry powder bonding mortar (polymer clay), single-component dry powder with good impermeability and good adhesion Strong water retention, good heat resistance, freeze-thaw resistance, long initial setting time, convenient for large-area operations, short initial setting to final setting time, can shorten the construction period, has good waterproof and anti-seepage capabilities, and can work on wet substrates
Used for When pasting facing bricks with waterproofing requirements, the project quality effect of waterproofing can be achieved, and better economic benefits can be obtained.
Mainly used for waterproofing of industrial and civil buildings and waterproofing of decorative tiles.
Main technical indicators
Compressive strength (
Impermeability (coating thickness,
Setting time Initial setting
Final setting
Bonding strength (< br /> Flexural strength (
Water resistance %
Alkaline resistance (% solution immersion) no change
Instructions for use
1. Base layer requirements
The base layer must be flat and firm. If there are cracks, honeycombs and other defects, they should be repaired first and meet the design requirements.
The base must be clean, and the floating ash, dirt, oil stains, etc. on the base surface should be cleaned before construction.
Preparation of second mortar
/> When using, add ~kg of water for every 100kg of dry clay powder. No additives are needed. Stir evenly into a thick paste manually or mechanically. There should be no raw dough. Let it sit for a few minutes and mix as you go. The mixed clay should be used up within the time limit to avoid waste caused by hardening and agglomeration. The construction temperature should not be lower than ℃.
Three engineering applications
Used for waterproofing of toilet, kitchen and bathroom walls, floors and exterior walls
Interface layer waterproof layer
Interface layer: Apply a layer of Yiguang mortar as a waterproof interface layer (approximately 100% thick) on the cleaned and kept moist base layer. The layer should be spread densely when scraping. Waterproof layer: After the interface layer is scraped, apply a layer of Yiguang mortar on it as a waterproof layer (thickness is about 100m). The direction of scraping should be consistent with the interface layer. When scraping, it should be fully covered and dense. After the waterproof layer is finally set, Maintenance should be carried out, usually when the waterproof layer is short of water and the surface turns white. You can lightly sprinkle water with a shower head several times a day, morning and evening. When the waterproof layer is exposed, the curing period will not be less than 10 days. If there is a protective layer on the surface, it should be maintained. or various veneers, the curing period shall not be less than days.
Used for waterproof bonding of various veneer tiles
Bonding layer
Single brick pasting: When pasting veneer tiles, it should be Scrape a layer of mortar on the cleaned base layer or the back of the brick as a bonding layer (approximate thickness), stick it from top to bottom or bottom up according to elastic lines or hanging lines, and wait until the bonding layer is finished. After setting, use caulking mud to seal the joints.
Double-sided coating: When the facing has waterproof requirements, the double-sided coating method can be used, that is, a layer of Yiguang mortar (thickness is about) can be applied on the base layer , and at the same time, apply a layer of clay mortar (approximately thick) on the back of the tiles for pasting, and use caulking mud to seal the joints after the bonding layer is finally set.
The dust on the tiles should be cleaned up before finalization , to avoid difficult cleaning after drying and contaminating the brick surface.
WhatsApp
