Yangzhou uv translucent film, Yangzhou kabu light box, Yangzhou soft film inkjet printing

Yangzhou light-transmitting film, Yangzhou Kabu light box, Yangzhou soft film inkjet printing Suzhou Chuangshimei Decoration Materials Co., Ltd. Li Gong, online.
Steps to install three-dimensional soft film ceiling
The first step is to basic common sense of installing three-dimensional soft film ceiling
According to the drawing design requirements, fix a circle around the horizontal position where the soft film ceiling needs to be installed. The ring support keel can be wooden square or square steel pipe. In some places, when the area is relatively large, it is required to install it in blocks. In order to achieve good results, a wooden square strip needs to be added in the middle. This is handled according to the actual situation.
After all the required wooden strips are fixed, the aluminum alloy keel of the soft film ceiling is then fixed and installed on the bottom surface of the supporting keel. Suzhou soft film ceiling
Things to note in the second step
After all the aluminum alloy keels for installing the soft film ceiling are fixed, install the soft film. First, open the soft film and use a special heating air cannon to fully heat it evenly. Then use a special inserting knife to tighten the soft film and insert it onto the aluminum alloy keel. Finally, trim the excess soft film around it completely.
After installation, clean the soft film ceiling with a clean towel.
The third step is the installation details of the soft film ceiling
First go to the construction site to see if there are conditions for installing the keel, that is, to see if the on-site wall is completed, whether the woodworking part is qualified, and the plastering part needs to be completed first. Pay special attention to that the woodworking part must be done according to our requirements, and the opening sizes for lights, air vents, etc. must be processed in advance.
The party permitted by the site conditions will enter the site for construction. First, the aluminum alloy keel keel must be fixed according to the carpentry required by the drawing design. Note that the corners must be straight and smooth at right angles, and the connections must be flat and dense.
Note that the lamp stand, air outlet, and light tube panel must be level with the surrounding keel, and must be firm and stable without swinging. Suzhou Soft Film Ceiling
For smoke detectors and ceiling lamps, first position them and then make a wooden chassis. The bottom surface of the wooden chassis should be polished smooth, and pay attention to the horizontal height. If it is too low, it will easily show the traces of the chassis.