Antistatic buffer bed

型号：

HCC

尺寸：

1200*100*75

产地：

山东省兖州市

Anti-static buffer bed Anti-static buffer bed can be roughly divided into two ways of fixing the buffer strip and the buffer bed frame. One is the steel structure and the other is the aluminum alloy connector hook. The steel structure is strong and durable, does not deform and is good at fixing. It will gradually replace aluminum alloy. In terms of the scope of use of the structure, steel structures can be used both underground and above. However, aluminum alloy structures are prohibited from using this kind of connection mechanism underground both internationally and in my country. Therefore, any company claiming that aluminum alloy structures can be used underground and issuing relevant flame retardant certificates is deceiving consumers. behavior. In the domestic market, it is not that manufacturers are unwilling to adopt this kind of steel pole structure, but that there is no such technology. From the perspective of the connection structure, using this connection method requires higher bonding performance between rubber and steel structures, and special hot vulcanization bonding must be used. technology (different from ordinary bonding methods).
A brief introduction to the anti-static buffer bed
The buffer bed sliders are reinforced with steel bars. Each slider can be reinforced by a steel base. Secondly, the adjustable supports on both sides of the buffer bed make it easier to install and can be installed on both sides. The adjustable support can be matched with any standard grooved angle belt, and the buffer bed has a strong wear compensation function. The flat holes made on both sides of the outer slider have a range of compensation for wear and are durable. The upper layer of the strong and durable buffer slider is low. The lower layer of friction coefficient polymer polyethylene material is an impact-absorbing rubber layer.
Characteristics of anti-static buffer bed
. It is easier to replace the buffer slider of buffer bed. Each buffer slider is fixed by four shaped bolts
. Wide application of buffer bed. Buffer bed can be Used for various belts with widths ranging from to to
. The structure is firm and durable. The base of the buffer bed is made of four I-beams and is very strong. Light and medium-duty brackets are made of bent-formed steel.
Shandong Century TEDA Telephone:
Landline:
Address: Yanzhou Development Zone Industrial Park