Molybdenum ore high gradient magnetic separator

Application scope--r:
.> Ferrous metals: recovery of false hematite, hematite, limonite, siderite, manganese ore, etc.
.> Non-ferrous metals: separation of wolframite, garnet and other minerals, etc.
.> Rare metals: recovery of tantalum-niobite, lepidolite, monazite, xenotime and other ores, etc.
.> Non-metals: purification and impurity removal of quartz, feldspar, kaolin and refractory materials. 4. Installation instructions:
.> The machine should be placed on the pre-made concrete foundation and adjusted to the level of the machine. Then pour concrete into the holes reserved for low-foot screws. After the concrete solidifies, tighten the anchor screws. .
.> After the machine is installed, there must be an electrical protection device and the electrician can test the machine after wiring. All power is controlled by an electric control cabinet.
.> Instructions for use and maintenance:
.> Before starting the test run, strictly check whether the installation of each part of the machine meets the requirements. Whether the screws and bolts are loose, you can gently pull the belt by hand to test whether there is any collision with the shell. At the same time, check the direction of rotation and strictly prohibit crushing flammable and explosive items to avoid accidents.
.> During production, uniform feeding should be maintained to ensure crushing quality and normal production. At the same time, motor overloading is strictly prohibited to ensure normal operation of the machine.
.> In addition to regularly checking the looseness of the fastening of each part, you should also pay attention to check the wear of wearing parts. If the wear is serious, they should be replaced in time to avoid damaging the main components. and take necessary fire prevention measures.
.> Due to the high speed, in addition to being installed correctly and firmly, good lubrication should be maintained to maintain the normal operation of the machine. Under normal circumstances, it is normal for the bearing temperature not to exceed 10°C. It is better to add butter and molybdenum disulfide high-speed butter to the main bearings once a week.